physics

A horizontal pipe has a cross sectional area of 40.0 cm^2 at the wider portions and 10.0 cm^2 at the constriction. Water is flowing in the pipe, and the discharge from the pipe is 6.00*10^-3 m^3/s(6.00 L/s). Find (a) the flow speeds at the wide and the narrow portions; (b) the pressure difference between those portions; (c) the difference in height between the mercury columns and the U-shaped tube.

  1. 👍
  2. 👎
  3. 👁
  1. a) use the equation of continuity

    b) Use bernoullis equation, I can check your work.

    c) Change pressure in b to mmHg.

    1. 👍
    2. 👎
    👤
    bobpursley
  2. Marqious, you err. Water is incompressible, so the flow speed has to change with area.

    1. 👍
    2. 👎
    👤
    bobpursley
  3. Pls ignore, Marquious has been banned because of spamming.

    1. 👍
    2. 👎
    👤
    bobpursley
  4. ok for part a I got v at the wide portion as .015 m/s and at the narrow portion .06 m/s but I have no idea if that is right

    1. 👍
    2. 👎
  5. it should be 1.5 m/s and 6.0 m/s

    1. 👍
    2. 👎

Respond to this Question

First Name

Your Response

Similar Questions

  1. Math

    Let V be the volume of a pyramid of height 15 whose base is a square of side 5. Part a). Use similar triangles to find the area of the horizontal cross section at a height y. Part b). Calculate V by integrating the

  2. Precal

    The velocity v of a fluid flowing in a conduit is inversely proportional to the cross- sectional area of the conduit.( Assume that the volume of the flow per unit of time is held constant .) Determine the change in the velocity of

  3. Physics

    A liquid (density = 1.65 g/cm^3) flows through two horizontal sections of tubing. In the first section the cross-sectional area is 10.0 cm^2, the flow speed is 275 cm/s, and the pressure is 1.20 x 10^5 Pa. This tubing then rises

  4. Physics

    Water is flowing in a pipe with a varying cross-section area, and at all points the water completely fills the pipe. At point 1 the cross-section area of the pipe is 0.080 m^2, and the magnitude of the fluid velocity is 2.50m/s.

  1. Physics

    Water flows at 12 m/s in a horizontal pipe with a pressure of 3.0 x 10 4 N/m2 . If the pipe widens to twice its original radius, what is the pressure in the wider section?

  2. phys

    Water flows steadily from an open tank into a pipe as shown in the figure. The elevation of the top of the tank is 12.3 m, and the elevation at the pipe is 3.80 m. The initial cross-sectional area of the pipe (at point 2) is

  3. Physics

    A wire of cross-sectional area 5.00x10^-6 m^2 has a resistance of 1.75 ohm. what is the resistance of a wire of the same material and length as the first wire, but with a cross-sectional area of 8.75x10^-6 m^2? I really want to

  4. Fluid Machineries

    Water is flowing in a pipe with a circular cross-section area, and at all points the water completely fills the pipe. At point 1, the cross-section area of the pipe is 0.080-m2 and the fluid velocity is 4.50 m/s. (a) What is the

  1. Physical Education

    Suppose that blood flows through the aorta with a speed of 0.35 m/s. The cross-sectional area of the aorta is 2.0x10-4 m2. (a) Find the volume flow rate of the blood (b) The aorta branches into tens of thousands of capillaries

  2. physics

    The intake in the figure has cross-sectional area of 0.75 m2 and water flow at 0.41 m/s. At the outlet, distance D = 180 m below the intake, the cross-sectional area is smaller than at the intake and the water flows out at 9.6

  3. Math Nightmare

    I need help The design of a new airplane requires a gasoline tank of constant cross-sectional area in each wing. A scale drawing of a cross section is shown here. The tank must hold 5000lb of gasoline, which has a density of 42

  4. College Physics

    A wire P has resistance R. If the wire is stretched and its length is increased by 10%, what would be the percentage change in its resistance? (Assume the density of the wire remains constant) A) - 10% B) 0 % C) 10% D) 20% My

You can view more similar questions or ask a new question.