physics

a giant crane was tested by lifting 2.232*10^6 kg load.find the magnitude of the force needed to lift the load with a net acceleration of 0m/s^2. if the same force is applied to pull the load up a smooth slope that makes 30 degrees with the horizontal, what would be the accel

  1. 👍 0
  2. 👎 0
  3. 👁 188
  1. see other post.

Respond to this Question

First Name

Your Response

Similar Questions

  1. Physics

    Fig.19 shows a crane lifting a car of mass 850 kg at constant velocity through a height of 12m in a time of 40s. The crane has a working efficiency of 60%. i) Calculate the tension in the lifting cable (in N) ii) Calculate the

    asked by cake on November 14, 2017
  2. Physics

    Calculate the height through which a crane can lift a load of 4t , when its motor of 4HP operates for 10s. [Take g=10N/kg ]

    asked by Tanish on August 13, 2014
  3. Physics

    In the figure, a chain consisting of five links, each of mass 0.100 kg, is lifted vertically with constant acceleration of magnitude a = 2.50 m/s2. Find the magnitudes of (a) the force on link 1 from link 2, (b) the force on link

    asked by Sarah on March 19, 2011
  4. physics

    3 Fig. 3.1 shows the arm of a crane when it is lifting a heavy box. Fig. 3.1 (a) By the use of a scale diagram (not calculation) of the forces acting at P, find the weight of the box. [5]

    asked by rida on January 7, 2014
  5. Physics

    One of the most powerful cranes in the world, operating in Switzerland, can slowly raise a load of 6000 tonne to a height of 12 m. (1 tonne = 1000 kg) The acceleration of gravity is 9.81 m/s2 . How much work is done by the crane?

    asked by Danny on February 26, 2013
  1. Physics

    1)How much work is done by a person lifting a 2 kg object from the bottom of a well at a constant speed of 2m/s for 5 s. Is the answer mgh=2*9.8*10m 2)A 2kg block slides on a rough horizontal surface. A force (magnitude = 4N)

    asked by Fiona on April 5, 2011
  2. physics

    A strip of rubber originally 75 mm long is stretched until it is 100 mm long. a.What is the tensile strain b.Why has the answer no units? c.The greatest tensile stress which steel of a particular sort of a particular sort can

    asked by farid on December 27, 2013
  3. physics

    Q. A 200 kg load is suspended by a cable from a crane . Two ropes are attached to the load , acting at 90 deg to each other. One rope exerts a pull of 220 N , at 10 deg below horizontal, the other rope exerts a force of 360 N at

    asked by john on February 7, 2014
  4. PHYSICS

    A large balloon of mass 237 kg is filled with helium gas until its volume is 318 m3. Assume the density of air is 1.29 kg/m3 and the density of helium is 0.179 kg/m3. (b) Calculate the buoyant force acting on the balloon.

    asked by Amy on November 8, 2012
  5. Physics

    The arm of a crane at a construction site is 16.0 m long, and it makes an angle of 13.9 ◦ with the horizontal. Assume that the maximum load the crane can handle is limited by the amount of torque the load produces around the

    asked by aquead on January 22, 2020
  6. physics

    A 25 ft long crane supported at its lower end by a pin is elevated by a horizontal cable. A 250 lb load is suspended from the outer end of the crane. The center of gravity of the crane is 10 ft from the pin and the crane weighs

    asked by sandhya on December 3, 2009

You can view more similar questions or ask a new question.