A block of ice at 0°C whose mass initially is m = 12.5 kg slides along a horizontal surface, starting at a speed vo = 4.10 m/s and finally coming to rest after traveling a distance d = 10.07 m. Compute the mass of ice melted as a result of the friction between the block and the surface. (Assume that all the heat generated owing to friction goes into the block of ice.)

i thought i had to use friction but it doesn't give me the coefficient of friction.

  1. 👍
  2. 👎
  3. 👁
  1. work done: 1/2 m v^2

    compute that.

    Then, heat = work done= massice*Hf

    1. 👍
    2. 👎

Respond to this Question

First Name

Your Response

Similar Questions

  1. Physics (Algebra-based)

    A block starts at rest and slides down a frictionless track except for a small rough area on a horizontal section of the track.It leaves the track horizontally, flies through the air, and subsequently strikes the ground. gravity=

  2. Physics

    A metal block of mass 5kg lies on a rough horizontal platform. If a horizontal force of 8 N applied to the block through its center of mass just slides the block on the platform, then the coefficient of limiting friction between

  3. cary collage

    "A 2.5-kg block slides down a 25 degree inclined plane with constant acceleration. The block starts from rest at the top. At the bottom, its velocity reaches 0.65 m/s. The length of the incline is 1.6m. a) What is the acceleration

  4. Physics

    Block 1 of mass m1 slides from rest along a frictionless ramp from height h and then collides with stationary block 2, which has mass m2 = 3m1. After the collision, block 2 slides into a region where the coefficient of kinetic

  1. Physics

    A block of mass m = 2.00 kg is released from rest h = 0.500 m from the surface of a table, at the top of a theta = 30.0° incline. The frictionless incline is fixed on a table of height H = 2.00 m. (a) Determine the acceleration

  2. Impulse and Momentum

    A bullet of mass m is fired at speed v0 into a wooden block of mass M. The bullet instantaneously comes to rest in the block. The block with the embedded bullet slides along a horizontal surface with a coefficient of kinetic

  3. physics

    A 2.5 kg block of ice at a temperature of 0.0 degrees Celcius and an initial speed of 5.7 m/s slides across a level floor. If 3.3 x 10^5 J are required to melt 1.0 kg of ice, how much ice melts, assuming that the initial kinetic

  4. physics

    Years ago, a block of ice with a mass of about 22kg was used daily in a home icebox. The temperature of the ice was 0.0 degrees Celsius when delivered. As it melted, how much heat did a block of ice that size absorb? The latent

  1. physics

    an ice skater applies a horizontal force to a 20 kg block on frictionless, level ice causing the block to accelerate uniformly at 1.4 m/s^2 to the right. after the skater stops pushing the block it slides onto a region of ice that

  2. physics

    A small cube of mass m1= 1.0 kg slides down a circular and frictionless track of radius R= 0.4 m cut into a large block of mass m2= 4.0 kg as shown in the figure below. The large block rests on a horizontal and frictionless table.

  3. physics

    a bullet of mass 0.05 kg strikes a wooden block of mass 5 kg and becomes embedded within the block. The block and bullet then fly off at 10 m/s after the collision. What was the original velocity of the bullet if the block was

  4. physics

    A 2.6 kg block of ice at a temperature of 0.0C and an initial speed of 5.3 m/s slides across a level floor. If 3.3 × 105 J are required to melt 1.0 kg of ice, how much ice melts, assuming that the initial kinetic energy of the

You can view more similar questions or ask a new question.