Physics

A hydraulic hoist has a ram of 30 cm diameter and a plunger of 1 cm diameter. If 70 N effort is applied to the plunger and the efficiency is 80%, find the maximum load it can raise.

  1. 👍 0
  2. 👎 0
  3. 👁 198
  1. load=.8*(30/1)^2=720 N check that.

    1. 👍 0
    2. 👎 0

Respond to this Question

First Name

Your Response

Similar Questions

  1. Math/Physics

    A block-and-tackle pulley hoist is suspended in a warehouse by ropes of lengths 2 m and 3 m. The hoist weighs 340 N. The ropes, fastened at different heights, make angles of 50° and 38° with the horizontal. Find the tension in

  2. science

    a hydrauli press has a ram of 30 cm diameter and plunger of 4.5cm diameter. find the the weight lifted by the hydraulic press when the force applied at the plunger is 500N

  3. physics

    A hypodermic syringe contains a medicine with the density of water (figure below). The barrel of the syringe has a cross-sectional area of 2.44 10-5 m2. In the absence of a force on the plunger, the pressure everywhere is 1.00

  4. physics

    A 2500N pile-driver ram falls 10m and drives a post 0.1m into the ground. Find the average impact of force on the ram.

  1. science

    1) In a syringe, what happens to the air paricles when you push the plunger? 2) In a syring, what happens the the air particles in the bubble from the bubble wrap when you pull up the plunger? 3) Are there more air particles in

  2. physics

    The small piston of a hydraulic lift has a diameter of 8 cm and its large piston has a diameter of 40cm. The lift raises a load of 15,000 Newtons. A. Determine the force that must be applied to the small piston. B. Determine the

  3. Physics

    The diameter of ram and plunger of a hydraulic press are 200 mm and 30 mm respectively.find the weight lifted by the hydraulic press when the force applied at the plungeris 400 N

  4. math

    A hydraulic plunger has a 12 cm diameter and a force of 350 kN acts on it. What is the pressure exerted on the plunger?

  1. Physics

    An engine block is supported by a rope hoist to an overhead beam. When the block is pulled to one side by a horizontal force exerted by another rope, the tension in the rope hoist is

  2. Physics

    The maximum gauge pressure in a hydraulic lift is 19.0 atm. What is the largest size vehicle (kg) it can lift if the diameter of the output line is 32.0 cm?

  3. Physics

    In the process of changing a flat tire, a motorist uses a hydraulic jack. She begins by applying a force of 49 N to the input piston, which has a radius r1. As a result, the output plunger, which has a radius r2, applies a force

  4. trig

    an electric hoist is used to life a piece of equipment y = 2.6 feet. the diameter on the hoist is x = 12 inches. find the number of degrees through which the drum must rotate (round to the nearest integer). *I do apologize, there

You can view more similar questions or ask a new question.