physics

A student thrusts a 0,20T magnet with a cross sectional area of 2.0 cm^2 into a coil of 400 turns in 0,50s. The coil has a resistance of 30 ohms and it is connected in series with a moving coil meter having a resistantace of 170 ohms. What is the average velocity and the current?

  1. 👍
  2. 👎
  3. 👁
  1. Figure the induced voltage (Faradays law)
    EMf=N *B*A/time

    Then divide this induced EMF by total resistance to get current.

    http://physics.bu.edu/~duffy/PY106/InducedEMF.html

    1. 👍
    2. 👎
    👤
    bobpursley
  2. EMF = BLV i don't have the length but im trying to find the velocity?

    1. 👍
    2. 👎
  3. go back to my formula. It is the basis for yours.

    1. 👍
    2. 👎
    👤
    bobpursley

Respond to this Question

First Name

Your Response

Similar Questions

  1. physics

    1. A closed magnetic circuit of cast steel contains a 6cm long path of cross sectional area 1cm square and a 2cm part of cross sectional area of 0.5cm square. A coil of 200 turns is wound around the 6cm length of the circuit and a

  2. Calculus

    A gutter with trapezoidal cross-section is to be made from a long sheet of stainless steel that is 30 cm wide by turning up one-fourth of the width on each side. What width across the top will give the maximum cross sectional

  3. physics

    A student wishes to measure the resistivity of glass. A teacher suggests that its resistivity is of the order of 10^6 Ω m which is very large. Resistivity ρ is defined by the equation: ρ = RA / l where R is resistance, A is

  4. Physical Education

    Suppose that blood flows through the aorta with a speed of 0.35 m/s. The cross-sectional area of the aorta is 2.0x10-4 m2. (a) Find the volume flow rate of the blood (b) The aorta branches into tens of thousands of capillaries

  1. Physics

    A liquid (density = 1.65 g/cm^3) flows through two horizontal sections of tubing. In the first section the cross-sectional area is 10.0 cm^2, the flow speed is 275 cm/s, and the pressure is 1.20 x 10^5 Pa. This tubing then rises

  2. phys

    Water flows steadily from an open tank into a pipe as shown in the figure. The elevation of the top of the tank is 12.3 m, and the elevation at the pipe is 3.80 m. The initial cross-sectional area of the pipe (at point 2) is

  3. physics

    Water flows steadily from an open tank into a pipe. The elevation of the top of the tank is 10.2 m, and the elevation at the pipe is 3.90 m. The initial cross-sectional area of the pipe is 6.40×10^−2 m; and at where the water

  4. Physics

    A hydraulic lift in a garage has two pistons: a small one of cross-sectional area 3.70cm2 and a large one of cross-sectional area 210cm2 . Part A If this lift is designed to raise a 3100-kg car, what minimum force must be applied

  1. physics

    a wire whose cross-sectional area is 4mm^2 is stretched by 0.1 mm by a certain load.if a similar wire double the area of cross-section is under the same load,then then elongation would be ans: 1)0.05mm

  2. physics

    A net charge of 47 mC passes through the cross-sectional area of a wire in 19.0 s. (a) What is the current in the wire? 1 A (b) How many electrons pass the cross-sectional area in 1.0 min? 2 . electrons I got 9.3e+22 for B but its

  3. College Physics

    A wire P has resistance R. If the wire is stretched and its length is increased by 10%, what would be the percentage change in its resistance? (Assume the density of the wire remains constant) A) - 10% B) 0 % C) 10% D) 20% My

  4. physics

    Muscles are attached to bones by means of tendons. The maximum force that a muscle can exert is directly proportional to its cross-sectional area A at the widest point. We can express this relationship mathematically as F~max=

You can view more similar questions or ask a new question.