Physics

posted by .

A hydraulic hoist has a ram of 30 cm diameter and a plunger of 1 cm diameter. If 70 N effort is applied to the plunger and the efficiency is 80%, find the maximum load it can raise.

  • Physics -

    load=.8*(30/1)^2=720 N check that.

Respond to this Question

First Name
School Subject
Your Answer

Similar Questions

  1. Physics

    In the process of changing a flat tire , a motorist uses a hydraulic jack. She begins applying a force of F1=8.6N to the input piston. As a result, the output plunger applies a force of F2=305N to the car. The height difference between …
  2. Physics

    A dentist's chair with a patient in it weighs 2260 N. The output plunger of a hydraulic system begins to lift the chair when the dentist's foot applies a force of 61 N to the input piston. Neglect any height difference between the …
  3. Please help asap science

    1.an engine develops 65kW over a period of 20minutes. The engine uses 5kg of petrol. Calculate the following:- A. The heat gegenerated B. The power generated by the petrol C. The efficiency Of the engine 2.A square steel plate with …
  4. please help me guys physical sciences

    1.an engine develops 65kW over a period of 20minutes. The engine uses 5kg of petrol. Calculate the following:- A. The heat gegenerated B. The power generated by the petrol C. The efficiency Of the engine 2.A square steel plate with …
  5. PHYSICS HELP!!

    A motorised gearbox has a reduction ratio of 50:1. The power input to the gearbox is 5 kW at 1440 RPM. The gearbox efficiency is 85% under maximum load conditions. The output shaft of the gearbox is attached to a winch drum of pitch …
  6. math

    A hydraulic plunger has a 12 cm diameter and a force of 350 kN acts on it. What is the pressure exerted on the plunger?
  7. physics

    The hydraulic oil in a car lift has a density of 8.54 x 102 kg/m3. The weight of the input piston is negligible. The radii of the input piston and output plunger are 5.01 x 10-3 m and 0.160 m, respectively. What input force F is needed …
  8. PHYSICS

    A dentist's chair with a patient in it weighs 2180 N. The output plunger of a hydraulic system begins to lift the chair, when the dentist's foot applies a force of 73.6 N to the input piston. Neglect any height difference between the …
  9. Engineering Science N4

    The diameter of the ram cylinder of a hydraulic press is 200mm. The stroke length of the plunger is 50mm. the effort on the plunger is 5% of the load. Calculate, i) the volume of the liquid needed per stroke if the load has to be lifted …
  10. science

    a hydrauli press has a ram of 30 cm diameter and plunger of 4.5cm diameter. find the the weight lifted by the hydraulic press when the force applied at the plunger is 500N

More Similar Questions