Practical Exercise 2 Electronics

posted by .

In the circuit shown in Figure A-1, where would you connect your meter’s test probes to measure the full
battery voltage?

  • Practical Exercise 2 Electronics -

    No figure.

  • Practical Exercise 2 Electronics -

    numer 2 c. 3 a. 6 d. 10 c. 11 a. 13 a. 15 d. 16 d.

Respond to this Question

First Name
School Subject
Your Answer

Similar Questions

  1. physcis problem ,please help

    A resistance in a circuit is 470§Ù ¡¾ 10%. When a meter with a full-scale voltage of 25V and error of ¡¾ 3% is used to measure the voltage across the resistance, the voltage was read as 12V. Obtain the power across the resistance …
  2. physics

    1.) Draw a set of 1.5-volt cells in a series circuit so that the total battery voltage is 9 volts. A.) how many cell does it take?
  3. physics

    1.) Draw a set of 1.5-volt cells in a series circuit so that the total battery voltage is 9 volts. A.) how many cell does it take?
  4. MITx: 6.002x Circuits and Electronics

    The step response of a circuit is its response to a step input, u(t). Knowing the step response of a linear circuit is extremely valuable as we can figure out the circuit's stability. In this problem we will analyze the circuit in …
  5. Circuit and electronics

    Here we analyze the time response of the circuit in Figure 3 which contains capacitive and resistive elements and a voltage source, VS. The voltage source is switched between two nodes in the circuit, and we observe the voltage response …
  6. Physics 112

    A battery is connected in series with a R = 0.26 Ω resistor and an inductor, as shown in the figure below. The switch is closed at t = 0. The time constant of the circuit is τ = 0.10 s, and the maximum current in the circuit …
  7. physics

    Three capacitors are connected to a battery of unknown voltage as shown in the circuit diagram above. The voltage drop across capacitor C 1 is V 1 = 11 . volts. a) What is the effective capacitance of the three capacitors?
  8. Physics

    a)In the series circuits, what do you notice about the voltage across each resistor compared with the voltage of the battery?
  9. electronics and circuits

    A battery in combination with a dependent current source is connected to a lamp in the circuit shown below in Figure 6-1. The battery is modeled as a voltage source in series with a resistor, Rbat, and has an open circuit voltage of …
  10. electronics and circuits

    The circuit below contains two dependent sources: a voltage controlled voltage source and a voltage controlled current source. Figure 3-1 The circuit elements have the following values: Vin=15V, R1=0.5Ω, R2=1.5Ω, R3=5Ω, A=2V/V and …

More Similar Questions