Engineering

posted by .

A certain OTA with a transconductance of 5000 µS has a load resistance of 10 kÙ. If the input voltage is 100 mV, what is the output current? What is the output voltage?

  • Engineering -

    Io = 5000uA/V * 0.1V = 500 uA=0.50 mA.

    Vo = Io*R = 0.50mA * 10k = 5 Volts.

Respond to this Question

First Name
School Subject
Your Answer

Similar Questions

  1. Digital Logic

    The input voltage to a certain op-amp inverting amplifier is 10 mV, and the output is 2 V. What is the closed-loop voltage gain?
  2. programming

    Consider the following selection statement where X is an integer test score between 0 and 100. input X if (0<=X and X<49) Output "you fail" Else if (50<=X and X <70) Output "your grade is" X Output " you did OK" Else if …
  3. Calculus

    The voltage,V, in an electrical unit is related to the current,I, and the resistance,R, by the equation V=IR. The current is decreasing at -4amps/sec as the resistance increases at 20ohms/sec. How fast is the voltage changing when …
  4. Science 30

    A step-up transformer has a coil with 100 turns and a coil with 10000 turns. If the input voltage is 12.0 kV, the input current is 10.0 A, and the output voltage is 1200 kV, then what is the output current
  5. Amplifiers

    An op amp has a maximum output voltage swing of 10 Vpp and a voltage gain of 100. What is the largest peak to peak input signal that can be applied to the input without clipping the output signal?
  6. Physics

    Design an AC circuit with R, L, and C components so that it can achieve output voltage in a given load to be doubled in amplitude (magnitude) while achieving increase in the phase shift of the output voltage of 45 more than the phase …
  7. Physics

    Posting this question again Design an AC circuit with R, L, and C components so that it can achieve output voltage in a given load to be doubled in amplitude (magnitude) while achieving increase in the phase shift of the output voltage …
  8. MITx: 6.002x Circuits and Electronics

    The step response of a circuit is its response to a step input, u(t). Knowing the step response of a linear circuit is extremely valuable as we can figure out the circuit's stability. In this problem we will analyze the circuit in …
  9. Physics

    The following circuits represent a logarithm amplifier The output voltage for a log amp with a diode can be determined by the formula below Vout = -(.025V)ln(Vin/IR*R1) , the ln is the natural logarithm of a number. Calculate in a …
  10. Math

    Input: 100 Output 10 Input: 30 Output 3 Input: 70 Output 7 Input: 40 Output 4 Input: 50 Output 5 What is the equation to show the relationship between the input and the output?

More Similar Questions