Technology

posted by .

Please tell me if this is correct:
14. Which type of machine has a rotating tool cutting motion and a linear tool feed motion?
a. milling machine
b. drill press
c. wood lathe
d. scroll saw

A?

  • Technology -

    A milling machine has a rotating tool bit. The table moves in the x and y directions, linear. Your answer is correct.
    Note that they carefully said WOOD lathe where you can move the bit all kinds of ways with your hand. With a metal lathe the bit is usually constrained to move back and forth especially if cutting threads.

Respond to this Question

First Name
School Subject
Your Answer

Similar Questions

  1. Motion

    Can sumone explain wot linear motion is? Wot's the opposite of linear motion?
  2. Financial Management

    The management of cooper Equipment is planning to purchase a new milling machine that will cost 160,000 installed.The old machine has been fully depreciated but can be sold for 15,000. The new machine will be depreciated on a straight-line …
  3. Technology

    I'm pretty sure I'm right, but please check to see if these are correct: 1. Which of the following lathe operations cuts an angled surface between two diameters on a workpiece?
  4. Technology

    please check these for me: 5. Which type of control ensures that finished goods perform within an acceptable range?
  5. physics

    a perpetual motion machine is a machine that, when set in motion, will never come to a halt. why is such a machine not possible?
  6. Algebra 2 (Linear Programming)

    Part A requires 4 hours per unit on a lathe and 3 hours per unit on a milling machine. Part B requires 2 hours per unit on a lathe and 5 hours per unit on a milling machine. 52 hours are available on the lathe and 60 hours are available …
  7. lens surface

    A spherical generator is used to produce a -15.00D surface on glass of refractive index 1.80. The diameter of the cutting tool is 80mm and the radius of the cutting surface is 4mm. What is the angle between the axis of the tool and …
  8. PHYSICS

    The cutting tool on a lathe is given two displacements, one of magnitude 4 cm and one of magnitude 3 cm, in each one of five situations (a) through (e) diagrammed in the figure below. Rank these situations according to the magnitude …
  9. Education/Technology

    Many classroom resource materials include Web resources that assist you in the tasks required for your classroom. What tool generates a seating chart or stores student progress?
  10. PHYSICS

    What power (in horsepower) is developed by a grinding machine whose wheel has a radius of 8.10 in and runs at 2.50 rev/s, when the tool to be sharpened is held against the wheel with a force of 43.0 lb?

More Similar Questions