# desperate help

posted by .

what is the conversion that takes place between a battery wiht a positve & negative with wires connected to a light bulb.

• Science -- not "desperate help" -

Science question here.

## Similar Questions

1. ### science

what is the conversion that takes place between a battery wiht a positve & negative with wires connected to a light bulb. first time left book at school
2. ### science

i have a picture of a battery a light bulb and a wire. i know to light the bulb it has to be a closed circuit. does it have to have 2 wires or can a closed circuit have only one wire?
3. ### Physical Science

1.Nico uses wire to connect a battery, light bulb, and a switch, but the light bulb doesn't light up. What might explain this problem?
4. ### physics

A light bulb is wired in series with a 133-Ω resistor, and they are connected across a 120-V source. The power delivered to the light bulb is 22.5 W. What are the two possible resistances of the light bulb?
5. ### Introduction to Electricity and Circuits

A light bulb is wired in series with a 142 resistor, and they are connected across a 120 V source. The power delivered to the light bulb is 22.3 W. What are the two possible resistances of the light bulb?

my science teacher showed us a diagram of a tiny light bulb on top of a D-cell battery,there was an electric wire touching the bottom of the light bulb.the electric wire was touching the bottom of the light bulb to the bottom of the …
7. ### Physics

Six light bulbs are connected in parallel to a 9.0 V battery. Each bulb has a resistance of 3.0 ohms. What is the current in each bulb?
8. ### science

a 6.85ohm light bulb is connected to a 12.0v battery. how much current flows through the bulb. how much power bulb consume
9. ### physics

You are in the lab with a 10 V battery. You have a 10 W light bulb and you want to put 1/2 A of current through the light bulb and 5 V across the light bulb. This will allow the light bulb to have a brightness proportional to 2.5 W. …
10. ### college physics

You are in the lab with a 10 V battery. You have a 10 W light bulb and you want to put 0.75 A of current through the light bulb and 7.5 V across the light bulb. This will allow the light bulb to have a brightness proportional to 5.625 …

More Similar Questions