physics

The drawing shows a uniform horizontal beam attached to a vertical wall by a frictionless hinge and supported from below at an angle θ = 38o by a brace that is attached to a pin. The beam has a weight of 346 N. Three additional forces keep the beam in equilibrium. The brace applies a force to the right end of the beam that is directed upward at the angle θ with respect to the horizontal. The hinge applies a force to the left end of the beam that has a horizontal component and a vertical component . Find the magnitudes of these three forces.

  1. 👍
  2. 👎
  3. 👁

Respond to this Question

First Name

Your Response

Similar Questions

  1. physics

    A uniform 8 m 1500 kg beam is hinged to a wall and supported by a thin cable attached 2 m from the free end of the beam as shown in the figure. The beam is supported at an angle of 30 degrees above the horizontal. a) free diagram

  2. physics

    A 16.0 m uniform ladder weighing 480 N rests against a frictionless wall. The ladder makes a 61.0° angle with the horizontal. (a) Find the horizontal and vertical forces the ground exerts on the base of the ladder when an 840 N

  3. Physics

    A uniform beam of length 1.0 m and mass 16 kg is attached to a wall by a cable that makes an angle of 30 degrees with the end of the beam, as shown in the figure. The beam is free to pivot at the point where it attaches to the

  4. Physics! plese help

    A 1320-N uniform beam is attached to a vertical wall at one end and is supported by a cable at the other end. A 1960-N crate hangs from the far end of the beam. Using the data shown in the figure, find (a) the magnitude of the

  1. Physics

    A purple beam is hinged to a wall to hold up a blue sign. The beam has a mass of mb = 6.7 kg and the sign has a mass of ms = 17.4 kg. The length of the beam is L = 2.83 m. The sign is attached at the very end of the beam, but the

  2. Physics

    A floodlight with a mass of 20.0 kg is used to illuminate the parking lot in front of a library. The floodlight is supported at the end of a horizontal beam that is hinged to a vertical pole. A cable that makes an angle of 30

  3. physics

    The figure shows a uniform beam of mass m pivoted at its lower end, with a horizontal spring attached between its top end and a vertical wall. The beam makes an angle è with the horizontal. (a) Find expression for the distance d

  4. physics

    A uniform bar of length 12 m and mass 3 kg is attached to a wall with a hinge that exerts a horizontal force Hx and a vertiscal force Hy on the bar. The bar is held by a cord that makes a 90 degree angle with respect to bar and 43

  1. Physics

    A 1.500m long uniform beam of mass 30.00 kg is supported by a wire as shown in the figure. The beam makes an angle of 10.00 degrees with the horizontal and the wire makes and angle of 30.00 degrees with the beam. A 50.00 kg mass,

  2. physics

    A uniform horizontal beam with a length of 8m and a weight of 200N is attached to a wall by a pin connection. Its far end is supported by a cable that makes an angle of 53° with the beam (Figure below). If a 600N person stands 2m

  3. physics

    A 9.0 m uniform beam is hinged to a vertical wall and held horizontally by a 5.0 m cable attached to the wall 4.0 m above the hinge, as shown below. The metal of the cable has test strength of 1.00 KN (kilo-Newton), which is the

  4. physics

    A uniform circular disk of mass 24.0 g and radius 40.0 cm hangs vertically from a fixed, frictionless, horizontal hinge at a point on its circumference. A horizontal beam of electromagnetic radiation with intensity 10.0 MW/m2 is

You can view more similar questions or ask a new question.