# electronics

At the critical frequency, the output of a filter is down from its maximum by

1. 👍 0
2. 👎 0
3. 👁 39

## Similar Questions

1. ### Physics

If the critical frequency of a low-pass filter is 5 kHz, what is the filter bandwidth?

asked by Bert on April 5, 2012
2. ### Mathematics Ms Sue help

A high pass filter with a cutoff frequency of 250 kHz is placed in a circuit after a low pass filter with a cutoff frequency of 150 kHz. Together, these filters create which type of filter?

3. ### Physics

I cannot find the answer anywhere on the reading or notes. Which of the following is a primary function of an adaptor that you plug into an ordinary electrical socket? It converts AC input to DC output. It converts AC input to AC

asked by Joe on March 15, 2018
4. ### circuits 2

Which of the following is true about the cut-off frequency ωB of a first-order low-pass filter? Suppose that the DC gain is 1. a.When the input is a sinusoid operating at ωB, the output is phase shifted from the input phase by

asked by student on April 6, 2018
5. ### Communication Technology

A digital fsk equipment transmits bipolar return to zero data. when sending a sequence of alternating ones and zeros how many different frequenies will be transmitted? The fsk is actually sending mark and space signals, isn't it?

asked by Mac on August 9, 2007
6. ### science

PSD of noise and desired signal is required to design Derivative-based filter Butterworth filter Wiener filter Notch filter

7. ### Circuits 2

let R=20kΩ, L=10mH, and C=40μF. Which angular frequency ω is attenuated most by this filter? (It would help you to first identify what type of filter this is.) Give your answer in terms of rad/sec, and omit units from your

asked by student on April 3, 2018
8. ### Calc 3

If a function of one variable is continuous on an interval and has only one critical number, then a local maximum has to be an absolute maximum. But this is not true for functions of two variables. Show that the function f(x,y)=

asked by Becky on October 1, 2012
9. ### Calculus

Find the critical point and the interval on which the given function is increasing or decreasing, and apply the First Derivative Test to the critical point. Let f(x)=4/x^2+1 Critical Point = Is f a maximum or minumum at the

asked by Ashton on November 14, 2018
10. ### Physics

#1.) A solar photovoltaic panel has an area of 3 m^2. The panel's maximum power output is 595 W @ 1100 W/m^2. a) What is its efficiency? b) If the panel receives 1300 W/m^2 of irradiance, what is its new power output? #2.) A solar

asked by Jim on December 4, 2010

More Similar Questions