Physics

a 5kg block is pushed 3m up a vertical wall with constant speed by a constant force of magnitude f applied at an angle of 30 degrees with the horizontal. if the coefficient of kinetic friction between block and wall is .3, determine the work done by a) f b) the force of gravity c) the normal force between block and wall. d) by how much does the gravitational potential energy increase during the block's motion?

  1. 👍
  2. 👎
  3. 👁
  1. kkkl

    1. 👍
    2. 👎
  2. awdad

    1. 👍
    2. 👎
  3. solving problem

    1. 👍
    2. 👎

Respond to this Question

First Name

Your Response

Similar Questions

  1. Physics

    A horizontal force of 0.80N is required to pull a 5kg bullet across a table top at a constant speed. With the block initially at rest, a 20g bullet fired horizontally into the block causes the block to slide 1.5m before coming to

  2. physics

    [20 pts] A 2.00 kg block is pushed against a spring with negligible mass and force constant k = 400 N/m, compressing it 0.220 m. When the block is released, it moves along a frictionless, horizontal surface and then up a

  3. Physics

    A block of mass 9.00 kg is pushed up against a wall by a force P that makes a 50.0° angle with the horizontal as shown below. The coefficient of static friction between the block and the wall is 0.245. Determine the possible

  4. physics

    A 5.3-kg block is pushed 2.3 m up a vertical wall with constant speed by a constant force of magnitude F applied at an angle of θ = 30° with the horizontal, as shown in the figure below. If the coefficient of kinetic friction

  1. physics

    A 4.00 kg block is pushed along the ceiling with a constant applied force of 85.0 N that acts at an angle of 55.0° with the horizontal, as in the figure below. The block accelerates to the right at 6.00 m/s2. Determine the

  2. physics

    A block with a mass of 0.5kg is pushed against a horizontal spring of negligible mass and spring constant 450 N/m until the spring is compressed a distance x. When it is released, the block travels along a frictionless, horizontal

  3. physics

    A large swinging ball is used to drive a horizontal iron spike into a vertical wall. The centre of the ball falls through a vertical height of 1.6m before striking the spike in the position shown. (there is this drawing of a wall

  4. physics

    A 12 N horizontal force pushes a block weighing 5.0 N against a vertical wall (Fig. 6-26).The coefficient of static friction between the wall and the block is 0.60, and the coefficient of kinetic friction is 0.40. Assume that the

  1. Physics Dynamics

    A 10-kg block is pushed against a vertical wall by a horizontal force of 100 N. What is the coefficient of static friction between the block and the wall if the block is about to slide down?

  2. Physic

    A block of mass 0.500 kg is pushed against a horizontal spring of negligible mass until the spring is compressed a distance x ( see Fig. below)The force constant ofthe spring is 450 N/rn. When it is released the block travels

  3. physics

    a block moves up 45degree incline w/ constant speed under the action of a force of 15n applied parallel to the incline.If the coefficient of kinetic friction is 0.3, determine the weight of the block and minimum force required to

  4. physics

    To measure the static friction coefficient between a 1.6-kg block and a vertical wall, the setup shown in the drawing is used. A spring (spring constant = 400 N/m) is attached to the block. Someone pushes on the end of the spring

You can view more similar questions or ask a new question.