# music

What is the diameter of the head joint of the flute?

1. 👍 0
2. 👎 0
3. 👁 75
1. Choices are below.

2 cm

1.7 cm

120 cm

1.2 cm

1. 👍 0
2. 👎 0
2. 1.2 cm

1. 👍 0
2. 👎 0
posted by brea

## Similar Questions

1. ### music

What is the diameter of the head joint of the flute? 2 cm 1.7 cm 120 cm 1.2 cm

asked by Anonymous on December 26, 2012
2. ### physics

a flute is essentially a pipe open at both ends. the length of a flute is approximately 66.1 cm. what is the third harmonic of a flute when all keys are closed, making the vibrating air column approximately equal to the length of

asked by jacquie on January 1, 2011
3. ### Physics

I made a pan flute with copper tubing (3/4 in diameter) to correspond to the following notes/lengths: C - 15.4cm D - 13.6cm E - 12.0cm G - 9.8cm A - 8.7cm The original instructions called for PVC pipe at 1/2in diameter, so the

asked by Anonymous on January 29, 2011
4. ### Physics (repost)

I made a pan flute with copper tubing (3/4 in diameter) to correspond to the following notes/lengths: C - 15.4cm D - 13.6cm E - 12.0cm G - 9.8cm A - 8.7cm The original instructions called for PVC pipe at 1/2in diameter, so the

asked by Anonymous on January 30, 2011
5. ### Physics => waves

It's a simple problem I think but I can't get the answers to match with the book. A particle fingering flute sounds note with frequency of 880Hz at 20 deg celcius(343m/s => sound wave speed) The flute is open at both ends. a) find

asked by ~christina~ on March 12, 2008
6. ### Physics

"A person is playing a small flute 10.75 cm long, open at one end and closed at the other, near a taut string having a fundamental frequency of 600.0 Hz. If the speed of sound is 344.0 m / s, for which harmonics of the flute will

asked by Kyle on June 4, 2012
7. ### Physics

Musicians can use beats to tune their instruments. One flute is properly tuned and plays the musical note A at exactly 440Hz. A second player sounds the same note and hears that her flute is slightly "flat" (that is, at too low of

asked by Carly on December 9, 2014
8. ### physics

A piccolo and a flute can be approximated as cylindrical tubes with both ends open. The lowest fundamental frequency produced by one kind of piccolo is 508.7 Hz, and that produced by one kind of flute is 220.3 Hz. What is the

asked by nop on June 26, 2016
9. ### Physics

A flute is designed to play middle C (262 Hz) as the fundamental frequency when all the holes are covered. The length of the flute is 0.655 m. Assume the air temperature is 20°C. How far from the end of the flute should the hole

asked by Luricela on May 31, 2010
10. ### Physics

Even when the head is held erect, as in the figure below, its center of mass is not directly over the principal point of support (the atlanto-occipital joint, point A). The muscles at the back of the neck should therefore exert a

asked by Beca on October 15, 2014

More Similar Questions