A thin, uniform rod is hinged at its midpoint. To begin with, one half of the rod is bent upward and is perpendicular to the other half. This bent object is rotating at an angular velocity of 6.8 rad/s about an axis that is perpendicular to the left end of the rod and parallel to the rod’s upward half (see the drawing). Without the aid of external torques, the rod suddenly assumes its straight shape. What is the angular velocity of the straight rod?

  1. 👍
  2. 👎
  3. 👁
  1. blah

    1. 👍
    2. 👎

    1. 👍
    2. 👎
  3. nag tatanong kapa sa amin at DAPAT nga kami ang magtanong sa iyo ABA NA MAN SOMOSOBRA KA NA


    1. 👍
    2. 👎
  4. Ayaw ko

    1. 👍
    2. 👎

Respond to this Question

First Name

Your Response

Similar Questions

  1. physics

    A uniform 8 m 1500 kg beam is hinged to a wall and supported by a thin cable attached 2 m from the free end of the beam as shown in the figure. The beam is supported at an angle of 30 degrees above the horizontal. a) free diagram

  2. Physics

    A long thin rod of mass M = 2:00 kg and length L = 75:0 cm is free to rotate about its center as shown. Two identical masses (each of mass m = .403 kg) slide without friction along the rod. The two masses begin at the rod's point

  3. physics

    A thin, uniform rod is hinged at its midpoint. To begin with, one-half of the rod is bent upward and is perpendicular to the other half. This bent object is rotating at an angular velocity of 7.1 rad/s about an axis that is

  4. physics

    A thin rod has a length of 0.25 m and rotates in a circle on a frictionless tabletop. The axis is perpendicular to the length of the rod at one of its ends. The rod has an angular velocity of 0.33 rad/s and a moment of inertia of

  1. AP Physics

    A uniform thin rod of length 0.3m and mass 3.5kg can rotate in a horizontal plane about a vertical axis through its center. The rod is at rest when a 3g bullet traveling in the horizontal plane of the rod is fired into one end of

  2. physics please help

    One end of a thin rod is attached to a pivot, about which it can rotate without friction. Air resistance is absent. The rod has a length of 0.59 m and is uniform. It is hanging vertically straight downward. The end of the rod

  3. Physics

    A rod is lying on the top of a table. One end of the rod is hinged to the table so that the rod can rotate freely on the tabletop. Two forces, both parallel to the tabletop, act on the rod at the same place. One force is directed

  4. Physics 121

    The disk has mass 10kg and radius 0.25m. The rod has mass 5kg, length 0.5m and radius 0.05m. The rod is split down the middle and is hinged so that its two halves can lay flat against the disk. Suppose that the disk and rod are

  1. Physics

    A grandfather clock has a pendulum that consists of a thin brass disk of radius r = 17.61 cm and mass 1.177 kg that is attached to a long thin rod of negligible mass. The pendulum swings freely about an axis perpendicular to the

  2. Science

    A uniform rod 1 metre long weighing 50N is supported horizontally on two knife edges placed 10cm each from its ends. What will be the reactions at these supports when 100N weight is suspended 10cm from the midpoint of the rod?


    A thin 2.82 m long copper rod in a uniform magnetic field has a mass of 44.2 g. When the rod carries a current of 0.238 A, it floats in the magnetic field. The acceleration of gravity is 9.81 m/s2 . What is the field strength of

  4. physics

    Resonance of sound waves can be produced within an aluminum rod by holding the rod at its midpoint and stroking it with an alcohol-saturated paper towel. In this resonance mode, the middle of the rod is a node while the ends are

You can view more similar questions or ask a new question.