AP Chemistry--gas law questions

Hey,

My AP Chem class did a lab for determing the molar mass of a volatile liquid by vapor density. There are a few calculations that I can't seem to get:

1.) The moles of air displaced by the volatile liquid vapor (at RT)
2.) The molar mass of air (calculated)
3.) Mass of air displaced by the volatile liquid vapor

1.) The aparent mass of vapor that occupied the flask at the boiling water temperature
2.) the volume of the flask
3.) Moles of gas occuping the flask at the BP of water.
4.) estimated molar mass of the unknown liquid

What we did is fashion an apparatus using copper wire and aluminum foil to an Erlenmyer Flask and injected 3-4 mL of this unknown liquid and then put the flask in a beaker with water on a hot plate to evaporate the liquid and then determine the mass of the flask, apparatus, AND vapor. Thanks in advance.

I'm sorry but there just isn't enough information here for me to be helpful. Nothing about the kind of apparatus, is the Cu wire and Al foil inside or outside the flask and do they react, nothing about masses (how much of what), etc. The volume of a flask is determined sometimes by weighing the empty flask, filling with water and reweighing, then calculating the volume from the density of water.

1. 👍
2. 👎
3. 👁

Similar Questions

1. Chemistry

A solution was made by dissolving 3.75 g of a pure non volatile solute in 95 g of acetone. The boiling point of pure acetone was observed to be 55.95°c, and that of the solution was 56.50°c. If the molar boiling point elevation

2. Chemistry 11

A hydrate of zinc chlorate, Zn(ClO3)2 .xH2O(s) contains 21.5% zinc by mass. Find the value of x. What I've done: Molar mass of Zn: 65.409 g/mol Molar mass of Cl: 2*35.453 =70.906 g/mol Molar mass of O: 6*15.9994 =95.9964 g/mol

1.SOLUBILITY: At 25C, the molar solubility of calcium phosphate in water is 1.1*10^{-7}M. Calculate the solubility in grams per liter. I m not sure how to convert M to g/L MOLAR MASS OF COLLIGATIVE PROPERTIES: 2.tert-Butyl alcohol

4. chemistry

Some liquids have enough attractions between molecules to form dimers. (Dimers are molecules formed from the combination of identical molecules, A + A --> A2.) What effect would this have on the experimental molar mass? This was a

1. Chemistry

Hey, for chemistry class we are given days in the lab to conduct an experiment, then answer a number of questions that correlate with that experiment and how we can make use of it. This week we looked at the Molar Fusion of Ice

2. Chemistry

Hi! there's 3 questions..if you can help on any that'd be great..thanks! 1. Volatile liquids with lower boiling points often give better results than those with higher boiling points. Suggest a reason for this. 2. What effect

3. 12 Chemistry

What is the molar enthalpy of combustion of magnesium? This was the lab question that I was asked to find after performing a lab based on Hess' law. I can't find anywhere in my notes how to calculate this, and the text book

4. Chem

A 10.0% by mass H2SO4(aq) solution has a density of 1.07 g·cm-3. How many milliliters of solution contain 8.34 g of H2SO4? What mass (in grams) of H2SO4 is in 248 mL of solution? It's been a while since I have had a chem

1. chemistry

472 mL of H2 gas was collected over water when 1.256 g of Zn reacted with excess HCl. The atmospheric pressure during the experiment was 754 mm Hg and the temperature was 26 degrees C. A. Write the balanced chemical equation (I

2. Chemistry labs in highschool

I was curious to know whether it was standardized practice to have labs for chemistry classes in highschool. I personally have never had labs for chemistry in highschool. In my state we have the Regents. You may or may not have

3. science(chem)

What is Zimmerman Reagent made of? (I know it is acidic b/c I was told after it burned a hole in my jeans) acid? You must mean Zimmermann-Reinhardt reagent (79 g MnSO4, 100 mL of concentrated H2SO4, and 200 mL of concentrated

4. AP Chemistry

The molar mass of a volatile liquid (one which vaporizes easily) can be determined by a the DUMAS METHOD.' In this process a small amount of the liquid (a few drops) is placed in a clean flask. The mouth of the flask is covered