Respond to this Question
Similar Questions
-
physics
Water flows at 0.830 m/s from a hot water heater, through a 450-kPa pressure regulator. The pressure in the pipe supplying an upstairs bathtub 3.70 m above the heater is 414-kPa. 1. What's the flow speed in this pipe?
asked by josh on June 26, 2018 -
physics
Water flows at 0.860m/s from a hot water heater, through a 450-kPa pressure regulator. The pressure in the pipe supplying an upstairs bathtub 3.70 m above the heater is 414-kPa. What's the flow speed in this pipe?
asked by sandra on November 19, 2013 -
physics
an electric hot water heater takes in cold water at 13.0 degrees celsius and delivers hot water. the hot water has a constant temperature of 45 degrees celsius when the "hot" faucet is left open all the times, and the volume flow
asked by Anonymous on June 18, 2014 -
math
A hot water heater measures 20" in diameter. What is the area of a metal base for the water heater, assuming a four-inch overhang for the base beyond the edge of the heater? (Round to the nearest tenth.)
asked by a on May 28, 2013 -
Math
A hot water heater measures 20" in diameter. What is the area of a metal base for the water heater, assuming a two-inch overhang for the base beyond the edge of the heater?
asked by Stacey on June 17, 2013 -
physics
The recovery time of a hot water heater is the time required to heat all the water in the unit to the desired temperature. Suppose that a 62-gal (1.00 gal = 3.79 x 10-3 m3) unit starts with cold water at 11 °C and delivers hot
asked by Anonymous on February 18, 2013 -
Physics
The recovery time of a hot water heater is the time required to heat all the water in the unit to the desired temperature. Suppose that a 62-gal (1.00 gal = 3.79 x 10-3 m3) unit starts with cold water at 11 °C and delivers hot
asked by Anonymous on February 18, 2013 -
AP Physics
You go to kitchen to boil water. You pour 280 gram of water to a container, and put the container on a 293 W electric heater. Assume that all the heat from the heater is used to heat the water. The specific heat of water is 4.19
asked by Sasami on December 3, 2009 -
physics
The heating element of a water heater in an apartment building has a maximum power output of 29 kW. Four residents of the building take showers at the same time, and each receives heated water at a volume flow rate of 12x10-5
asked by krissy on November 17, 2015 -
physics********************
true or false- if you only want a small volume of hot water, you should place the immersion heater near the bottom of the hot water tank?
asked by rose on October 27, 2011