statistics

the breaking strength of a cable known to be normally distributed with a mean of 4000kg and a standard deviation of 25kg.The manufacture prefers that at least 95% of its products meet a strength requirement of 4050 kg.Is this requirement being met? If not, by changing the process parameter what would the process mean target would be?

  1. 👍 0
  2. 👎 0
  3. 👁 131

Respond to this Question

First Name

Your Response

Similar Questions

  1. Physics

    In a repair shop a truck engine that has mass 429 kg is held in place by four light cables (Figure 1) . Cable A is horizontal, cables B and D are vertical, and cable C makes an angle of 37.1∘ with a vertical wall. Tension in

    asked by David on October 2, 2015
  2. Math Help Please!!!!

    The breaking strengths (say, y) for one foot square samples of a particular synthetic fabric are approximately normally distributed with a mean of 2280 pounds per square inch and a standard deviation of 10.6 psi. a) find the

    asked by Taylor on February 23, 2013
  3. physics

    A helicopter flies to the right (in the +x direction) at a constant speed of 14 m/s, parallel to the surface of the ocean. A 1200 kg package of supplies is suspended below the helicopter by a cable as shown in the figure: the

    asked by Jonas on September 27, 2018
  4. Physics

    The inner conductor of a coaxial cable has a radius of 0.900 mm, and the outer conductor's inside radius is 5.00 mm. The space between the conductors is filled with polyethylene, which has a dielectric constant of 2.30 and a

    asked by Physics on May 13, 2010
  5. Intro to computers

    you are trying to network two laptops together using a Ethernet cable but it isn't working. Which of the following selections might explain why it isn't working? A) using outdated CAT 3 cable B) using straight-through cable C)

    asked by carol on June 17, 2015
  1. Physics!

    The cable supporting a 2100kg elevator has a maximum strength of 2.19×10^4 N. What maximum upward acceleration can it give the elevator without breaking?

    asked by Physics on September 23, 2009
  2. physics

    A strip of rubber originally 75 mm long is stretched until it is 100 mm long. a.What is the tensile strain b.Why has the answer no units? c.The greatest tensile stress which steel of a particular sort of a particular sort can

    asked by farid on December 27, 2013
  3. Physics

    The cable supporting a 2125 kg elevator has a maximum strength of 21,750 N. What maximum upward acceleration can it give the elevator without breaking. I would like step by step, with explanations behind the steps. Thank you :)

    asked by Braedon on March 27, 2018
  4. physics

    A 7000 kg helicopter accelerates upward at 0.70 m/s/s while lifting a 1000 kg car to a mountaintop for a TV commercial photo shoot. -What tension must the cable be able to withstand without breaking?

    asked by Diana on October 18, 2010
  5. Statistics/I am confused

    The breaking strength (in pounds) of a certain new synthetic is normally distributed, with a mean of 115 and a variance of 25. The material is considered defective if the breaking strength is less than 105 pounds. What is the

    asked by Mary Ann on May 31, 2014
  6. Physics 2

    A cyllindrical copper cable carries a current of 1200 A. There is a potential difference of 1.6×10−2 V between two points on the cable that are 0.24 m apart. What is the radius of the cable?

    asked by Chris on February 11, 2010

You can view more similar questions or ask a new question.