# College Physics

1. A spring gun is made by compressing a spring ina tube and then altching the spring at the compressed position. A 4.97-g pellet is placed against the compressed and latched spring. The spring latches at a compression of 4.06 cm, and it takes a force of 9.12 N to compress the spring to that point.

a. If the gun is fired vertically how fast (m/s) is the pellet moving when it loses contact with the spring?

I thought for this you would write out conservation of energy formula:
1/2mv^2 = mgy+1/2kx^2 and solve for V
K = -F2/x=224.631 N/m
y=x=.0406m
m = .00497 kg

The TA said I'm getting it wrong because I have to account for gravitational potential energy at both ends by she's wrong in saying that because it doesn't make a difference in the equation since mgy = mg(y2-y1)

I get v = 8.68 m/s^2 but it's supposed to be 8.59 m/s^2

b. To what maximum height (m) will the pellet rise? (as measure from the original latched position)

For this again I wrote out the formula for energy conservation:
mgYc = mgYa + 1/2kx^2 and solved for Yc
K = -F2/x=224.631 N/m
Ya=x=.0406m
m = .00497 kg

Again I'm off by such a minor amount... I get 3.84 m instead of 3.80.

1. 👍 0
2. 👎 0
3. 👁 440

## Similar Questions

1. ### Physics

A spring-loaded toy gun is used to shoot a ball of mass m=1.5 kg straight up in the air. The spring has spring constant k=667 N/m. If the spring is compressed a distance of 25.0 centimeters from its equilibrium position and then

asked by Eden on October 17, 2010
2. ### physics

A 0.5-kg block slides along a horizontal frictionless surface at 2m/s. It is brought to rest by compressing a very long spring of spring constant 800N/m. The maximum spring compression is:

asked by charmen angcud on April 10, 2017
3. ### Physics

A cylinder is fitted with a piston, beneath which is a spring, as in the drawing. The cylinder is open at the top. Friction is absent. The spring constant of the spring is 4100 N/m. The piston has a negligible mass and a radius of

asked by Mary on April 24, 2007
4. ### Physics

Suppose that you have a spring gun that you use to launch a small metal ball. You try the first two settings of the gun. The first setting compresses the spring by 1 cm and fires the ball a distance of 0.25 m . The second setting

asked by Susan on February 3, 2012
5. ### Physics

A cork gun contains a spring whose spring constant is 18.0 N/m. The spring is compressed by a distance ∆X = 6.0 cm and used to propel a cork of mass 7.66 g from the gun. Assuming the cork is released when the spring passes

asked by Lina on December 17, 2013
1. ### Physics

A block of mass m is placed in a smooth-bored spring gun at the bottom of the incline so that it compresses the spring by an amount x_c. The spring has spring constant k. The incline makes an angle theta with the horizontal and

asked by Trevor on March 13, 2011
2. ### physics

You push a 2.0 kg block against a horizontal spring, compressing the spring by 15 cm. Then you release the block, and the spring sends it sliding across a tabletop. It stops 75 cm from where you released it. The spring constant is

asked by Meghan on November 7, 2010
3. ### Physics

The launching mechanism of a toy gun consists of a spring of unknown spring constant, as shown in Figure P5.33a. If its spring is compressed a distance of 0.140 m and the gun fired vertically as shown, the gun can launch a 24.0 g

asked by Sarah on June 16, 2011
4. ### physics

A 0.250 kg block on a vertical spring with a spring constant of 5.00 103 N/m is pushed downward, compressing the spring 0.120 m. When released, the block leaves the spring and travels upward vertically. How high does it rise above

asked by Anonymous on January 5, 2011
5. ### physics-energy

A toy gun uses a spring to project a 5.3 g soft rubber sphere vertically. The spring constant is 8.0 N/m, the barrel of the gun is 15 cm long, and a constant frictional force of 0.032 N exists between barrel and projectile. How

asked by nate on February 19, 2010
6. ### physics

A 710 gram block is released from a height h above an ideal spring of spring constant 400 N/m. The block sticks to the spring, and comes momentarily to rest after compressing the spring by an amount of 18.7 cm. DropOnSpring (a)

asked by Anonymous on October 19, 2013