chemistry

About how much should the boiling point of pure water differ from .5m 1m and 1.5m aqueous solutions of NaCl and same molal solutions of CaCl2 Trying to check experimental data from van't hoff factor lab

  1. 👍 0
  2. 👎 0
  3. 👁 216
  1. You can calculate this from
    delta T = i*Kb*m
    i = 2 for NaCl and 3 for CaCl2.

    1. 👍 0
    2. 👎 0

Respond to this Question

First Name

Your Response

Similar Questions

  1. Chemistry hw

    Assuming 100% dissociation, calculate the freezing point and boiling point of 3.13 m SnCl4(aq). Tf=? Tb=? My work: SnCl4 with 100% dissociation gives a van't hoff factor of 5, 1Sn 4+ ion and 4 Cl- ions deltaT = i x Kf x m for

    asked by Akle on February 19, 2012
  2. Chemistry

    The molal boiling-point constant for water is 0.51 degrees C/molal. The boiling point of a 1.00 molal solution of Ca(NO3)2 should be increased by: A.) exactly 1.53 or B.) Somewhat less than 1.53 This is how I worked the problem:

    asked by Marcus on February 21, 2013
  3. AP Chemistry

    From the following: pure water solution of C12H22O11 (m=0.01) in water solution of NaCl (m=0.01) in water solution of CaCl2 (m=0.01) in water choose the one with the a) highest freezing point b) lowest freezing point c) highest

    asked by Anonymous on November 24, 2010
  4. Chemistry

    In a mountainous location, the boiling point of pure water is found to be 95 degrees Celsius. How many grams of sodium chloride much be added to 1 kg of water to bring the boiling point back to 100 degrees Celsius? Assume that

    asked by Mike on September 14, 2010
  1. chemistry

    A 50/50 blend of engine coolant and water (by volume) is usually used in an automobile\'s engine cooling system. If your car\'s cooling system holds 4.20 gallons, what is the boiling point of the solution? Make the following

    asked by Morgan Parker on March 2, 2013
  2. science

    From the following: pure water solution of C12H22O11 (m=0.01) in water solution of NaCl (m=0.01) in water solution of CaCl2 (m=0.01) in water choose the one with the a) highest freezing point b) lowest freezing point c) highest

    asked by Sal on October 5, 2010
  3. HVAC

    Two HVAC technicians are discussing the properties of water.Technician A says that if the pressure of water is raised,the boiling point will decrease.Technician B says that placing water in a vacuum will cause its boiling point to

    asked by simon on December 13, 2017
  4. Chemistry

    A solution contains 3.75g of nonvolatile pure hydrocarbon in 95g acetone. The boiling points of pure acetone and the solution are 55.95C and 56.50C, respectively. The molal boiling point constant of acetone is 1.71 C*kg/mol. What

    asked by James on February 10, 2011
  1. chemistry

    At a certain elevation, the boiling point of water is 98.5°C. How much energy is needed to heat 35.0 mL of water to the boiling point at this elevation if the water initially was at 23.4°C? (Cp=75.38J/(mol*C), d= 1.00g/mL)

    asked by Danny on April 1, 2015
  2. chemistry

    A solution is prepared by dissolving 104.1 grams of barium chloride, BaCl2 in 1000. grams of water? What is the boiling point of this solution? [The boiling point elevation constant for water is 0.52°C/mole solute in 1000g of

    asked by Natalya on October 30, 2014
  3. Chemistry

    Assuming complete dissociation of the solute, how many grams of KNO3 must be added to 275 mL of water to produce a solution that freezes at -14.5 degrees celcius ? The freezing point for pure water is 0.0 degrees celcius and Kf is

    asked by Nikita on January 16, 2011
  4. Chemistry

    In a mountainous location, the boiling point of pure water is found to be 95°C. How many grams of sodium chloride must be added to 9 kg of water to bring the boiling point back to 101°C? Assume that i = 2.

    asked by flame on January 27, 2013

You can view more similar questions or ask a new question.