Chemistry

A 3.23 gram sample of a sodium bicarbonate mixture was reacted with excess acid. 48.52 mL of the evolved gas was collected of the water at .930 atm. and 23.0 degrees C. What is the percentage of sodium bicarbonate in the original mixture?

  1. 4
asked by Adele
  1. I would convert 0.930 atm to mm Hg. 0.930*760 = ??
    Then use (P1V1/T1) = (P2V2/T2) to convert 48.52 mL to V2 at STP. Remember to correct P1 for vapor pressure of water. Look up v.p. H2O at 23 C and subtract from P1.
    Finally, mL CO2 at STP x (1 mol/22,400 mL) converts to moles CO2, that times molar mass CO2 converts to grams and (g/mass sample)*100 = %CO2
    Post your work if you get stuck.

    posted by DrBob222
  2. I started to use PV=nRT.
    So,
    n = (.930 atm)(.04852 L)
    ------------------ = 1.86 x 10^ -3
    (.0821) (296 K) mol

    I multiplied that by 84 g/mol (molar mass of sodium bicarbonate) and then by 100%....which equated to 15.62%.
    That seems off to me. Do you know what I'm doing wrong?

    posted by Adele
  3. The first thing you did wrong is that you didn't correct for the vapor pressure of water at 23 C. Therefore, the n you calculated is n for moles CO2 + moles H2O whatever that means (it means the gas is wet and not dry). To correct, look up the vapor pressure of water at 23 C (usually given in tables in mm Hg; therefore, convert that to atm and subtract from the 0.930 atm if you want to continue with your method.) Then recalculate n, which this time will be for the dry gas. The n you have should be a little lower than 0.00186 but not by much. The second thing you did wrong is that you calculated grams NaHCO3 (which you should have done) BUT you didn't calculate that as the percent of the 3.23 g sample.
    %NaHCO3 = (mass NaHCO3/mass sample)*100 = ?? I think you should end up with some value about 4 or 5%.

    Please note that if you worked it as I did, that I calculated %CO2 and not %NaHCO3. There is nothing wrong with what I did; however, I didn't answer the question (at least not completely).
    I hope this helps.

    posted by DrBob222

Respond to this Question

First Name

Your Response

Similar Questions

  1. Chemistry

    A 3.23 gram sample of a sodium bicarbonate mixture was reacted with excess acid. 48.52 mL of the evolved gas was collected over water at 0.930 arm and 23.0 degrees Celsius. What is the percentage of sodium bicarbonate in the
  2. Chemistry

    You have acid reflux and you take teaspoon of sodium bicarbonate. Assuming that one gram of sodium bicarbonate made it down into your stomach, how many moles of acid could it neutralize?
  3. Chemistry

    Assume you started with a 0.642 gram sample of Sodium Bicarbonate and aster adding an excess of hydrochloric acid and carrying out the experiment correctly, you calculateed there was a 94.8% yield of sodium chloride. What was the
  4. chem

    In order to neutralize the acid in 10.0 mL of 18.0 mol/L sulfuric acid that was spilled on a laboratory bench, sodium bicarbonate (baking soda) was used. The container of baking soda had a mass of 155.00g before this use, and out
  5. chemistry

    A 20.0 gram sample is a mixture of sodium phosphate ,sodium mono-hydrogen phosphate,sodium dihydrogen phosphate and sodium chloride. The sample is dissolved in 100.0 ml of deionized water and titrated with 1.5 M hydrochloric acid.
  6. chemistry

    A 20.0 gram sample is a mixture of sodium phosphate ,sodium mono-hydrogen phosphate,sodium dihydrogen phosphate and sodium chloride. The sample is dissolved in 100.0 ml of deionized water and titrated with 1.5 M hydrochloric acid.
  7. science (chem)

    I have a question. I'm forming Isopentyl acetate by the esterfication of acetic acid with isopentyl alcohol. The rxn is shifted so that the ester is produced by using excess acetic acid. In isolating the ester, the excess acetic
  8. AP Chemistry

    A mixture of aluminum and zinc metal is used in 2 experiments described below: A- A 1.7 gram sample of the mixture is reacted with excess hydrochloric acid and the resulting hydrogen gas is collected over water. The reaction takes
  9. Chemistry

    1. Consider a 1.00g unknown sample that contains 62.0% sodium carbonate and 38.0% sodium bicarbonate, NaHCO3, by mass. When this sample is dissolved in water, how many mL of 0.200M HCl will be required to convert all of the
  10. chemistry 30a

    What volume (in mL) of an 8% w/v acetic acid solution would be needed to form 2.2 L of carbon dioxide gas at 25.2 degrees Celsius and 0.9982 atm? Assume the acid is reacted with excess sodium bicarbonate, and round your final

More Similar Questions