Physics

The 3.0 -diameter water line in the figure splits into two 1.0 -diameter pipes. All pipes are circular and at the same elevation. At point A, the water speed is 2.0 and the gauge pressure is 50 .What is the gauge pressure at point B?

I know we have to find P in kPa, but am unsure how to set this problem up or what to plug in where. Any help would be great

  1. 👍
  2. 👎
  3. 👁

Respond to this Question

First Name

Your Response

Similar Questions

  1. math

    tree pipes of diameter 1 m are held together by a taut metal band as shown. Find the length in meters, of the metal band.

  2. Chemistry

    heptane and water do not mix, and heptane has a lower density (0.684g/mL) than water (1.00g/mL). A 100mL graduate cylinder with an inside diameter of 3.10 cm contains 39.90g of heptane and 34.00g of water. What is the combined

  3. math

    Three water pipes are used to fill a swimming pool. The 1st pipe alone takes 8 hours to fill the pool, the 2nd pipe alone takes 12 hours to fill the pool, and the 3rd pipe takes 24 hours to fill the pool. If all 3 pipes are opened

  4. science

    The pressure on a fluid at rest in a pipe increases by 20 Pa. How does this change in pressure affect the pressure on the fluid in the rest of the pipe? 1. The pressure in the rest of the fluid stays the same because the pressure

  1. Math

    Four pipes can fill a tank in 70 minutes.how long will it takes to fill the tank if 7 pipes are used.

  2. Science

    How does lead get into water?(1 point) It occurs naturally in water. It is a byproduct of detergents interacting with organic matter. It leaches into water as old pipes corrode. It is released into waterways with industrial waste.

  3. Physics

    The 3.0 cm-diameter water line splits into two 1.0cm-diameter pipes. All pipes are circular and at the same elevation. At point A, the water speed is 2.0m/s and the gauge pressure is 50kPa. What is the gauge pressure at point

  4. Fluid Mechanics

    Water flows into a cylindrical tank through pipe 1 at a rate of 25 ft/s and leaves through pipe 2 at 10 ft/s and through pipe 3 at 12 ft/s. Pipe 4 is an open air vent. Internal diameters of the pipes are: D1=3 in, D2= 2 in, D3=2.5

  1. Calc 2

    The figure shows a semicircle with radius 1, horizontal diameter PQ, and tangent lines at P and Q. At what height above the diameter should the horizontal line be placed so as to minimize the shaded area? I would post the figure

  2. maths

    To fill a swimming pool two pipes are to be used.If the pipe of larger diameter I'd used for 4 hours and the pipe of smaller diameter for 9 hours only half the pool can be filled .Find ,how long it would take for each pipe to fill

  3. Algebra

    Pipes A and B can fill a tank in 5 and 6 hours respectively. Pipe C can empty it in 12 hours. If all the three pipes are opened together, how long will it take to fill the tank from empty to full?

  4. Physics as repost please answer and help

    Silver plating: A student attempts the process of silver plating to determine the mass of a silver atom. a series of objects are measured, then electroplated for a measure period of time, while maintaining a steady current through

You can view more similar questions or ask a new question.