A 32 g ball rolls around a 40 cm diameter L-shaped track, shown in the figure below, at 60 rpm. Rolling friction can be neglected. What is the magnitude of the net force exerted on the ball?

  1. 👍
  2. 👎
  3. 👁

Respond to this Question

First Name

Your Response

Similar Questions

  1. Geometry

    The figure below represents an oval shaped track. the rounded portion of the track are semicircles. If you were to run one lap of this track, how far would you run? Pic: LONG OVAL, THE WHOLE LENGTH IS 106 FT. THERE ARE TWO LINES

  2. Physics

    A ball of mass 522 g starts at rest and slides down a frictionless track, as shown below. It leaves the track horizontally, striking the ground a distance x = 0.81 m from the end of the track after falling a vertical distance h2 =

  3. physics

    A tennis ball is a hollow sphere with a thin wall. It is set rolling without slipping at 4.24 m/s on a horizontal section of a track. It rolls around the inside of a vertical circular loop 90.0 cm in diameter and finally leaves


    Need help urgent!!! A system consist of a ball of M2 and a uniform rod of M1 and length d. The rod is attached to a horizontal frictionless rotates at an angular speed w, as shown in the figure. The rotational inertia of the rod

  1. Science

    A ball rolls down an inclined track 2m long in 4s.find time taken to cover the second metre of the track

  2. physics

    A steel ball rolls with constant velocity across a tabletop 0.950m high. IT rolls off and hits the ground +0.352m horizontally from the edge of the table. How fast was the ball rolling?

  3. physics

    A ball rolls forwards and backwards on a curved track as shown in Fig. 1.1. ball flexible track Fig. 1.1 It is suggested that the period T of the oscillations is related to the radius r of the ball and the radius of curvature C of

  4. Physics

    A ball and a thin plate are made from different materials and have the same initial temperature. The ball does not fit through a hole in the plate, because the diameter of the ball is slightly larger than the diameter of the hole.

  1. Physics (Rolling)

    In Fig. 11-35, a solid brass ball of mass m will roll smoothly along a loop-the-loop track when released from rest along the straight section. The circular loop has radius R, and the ball has radius r

  2. physics

    A solid ball of mass m and radius r rolls without slipping through a loop of radius R, as shown in the figure. From what height h should the ball be launched in order to make it through the loop without falling off the track? (Use

  3. Physics

    VERY URGENT PLEASE HELP!!! A block of mass 493 g is pushed against the spring (located on the left-hand side of the track) and compresses the spring a distance 4.9 cm from its equilibrium position (as shown in the figure below).

  4. Physics

    A child rolls a ball on a level floor 3.4 m to another child. If the ball makes 9.0 revolutions, what is its diameter?

You can view more similar questions or ask a new question.