Chemistry
 👍
 👎
 👁

 👍
 👎
Respond to this Question
Similar Questions

Math
You flip a coin 30 times and get heads 11 times, so the chance of getting heads is 11\30. Is this an example of theoretical or experimental probability? A. Theoretical B. Experimental Is the answer B? Thank you

Math
A number cube is rolled 100 times. The results are shown in the table below. Outcome: 1, 2, 3, 4, 5, 6. Number of times rolled: 22, 18, 9, 11, 19, 21. Find the experimental probability and express it as a percent. P(even) = ? A.

chemistry
The pH of a solution prepared by mixing 45 mL of 0.183 M KOH and 65 mL of 0.145 M HCl is i solved it but my answer is wrong. the right one is 1.97. am i missing a step? moles of HCl left over = (moles of HCl) – ( moles of KOH)

Math
The table below shows the results of flipping two coins. how does the experimental probability of getting at least one tails compare to the theoretical probability of getting at least one tails Outcome: HH HT TH TT # of times

Chemistry
How do I prepare 100mL of 10g/L HCl from concentrated HCl(37%HCl, density 1.19g/mL) Is it 2.28mL of conc HCl dilute to 100mL with water? Please show the calculation steps.

CHEM HELP
what is the theoretical mole ratio NaCl to NaHCO3 How do you determine the percentage error of an experimental mole ratio It would be easier for us to help you if we had the entire problem instead of just parts of it. However,

science
Given the list of pKa values, which acid will have the largest amount of conjugate base present in the solution at equilibrium? Acid: Pka: H20 15.7 NH3 38 HCL 8 NH4+ 9.2 H2O NH3 NH4+ HCl

math
A sixsided, fair number cube is rolled 100 times as part of an experiment. The frequency of the roll of the number 3 is 20. Which statement about rolling a 3 is correct? The theoretical probability is 1/6. The experimental

Math
How can you use theoretical probability to make predictions in realworld situations? Complete the statement. You can find the theoretical probability of an event and then use it to make a prediction by setting up a IS THIS

Chemistry
A titration setup was used to determine the unknown molar concentration of a solution of NaOH. A .025 M HCl solution was used as the titration standard. The following data were collected. Trial 1 Trial 2 Trial 3 Initial NaOH Buret

AP Chem
When NH3 gas is introduced at one end of a long tube while HCl gas is introduced simultaneously at the other end, a ring of white ammonium chloride is observed to form in the tube after a few minutes. This ring is closer to the

chemistry
10). What is the molarity of an HCl solution if 42.5 mL of a 0.110 M KOH solution is needed to titrate a 25.0mL sample of the acid? A) 0.187 M HCl B) 0.587 M HCl C) 0.0647 M HCl D) 5.35 M HCl E) 1.70 M HCl
You can view more similar questions or ask a new question.