Physics

The arm of a crane at a construction site is 13.1 m long, and it makes an angle of 20° with the horizontal. Assume that the maximum load the crane can handle is limited by the amount of torque the load produces at the base of the arm.

(a) What is the magnitude of the maximum torque the crane can withstand if the maximum load the crane can handle is 465 N?

(b) What is the maximum load for this crane at an angle of 25° with the horizontal?

1. 👍 0
2. 👎 0
3. 👁 526

Similar Questions

1. physics

a magnetic crane left a mass 1500 through a vertical height of 40m.calculate the work done in operating the crane

2. Physics

Fig.19 shows a crane lifting a car of mass 850 kg at constant velocity through a height of 12m in a time of 40s. The crane has a working efficiency of 60%. i) Calculate the tension in the lifting cable (in N) ii) Calculate the

3. physics

3 Fig. 3.1 shows the arm of a crane when it is lifting a heavy box. Fig. 3.1 (a) By the use of a scale diagram (not calculation) of the forces acting at P, find the weight of the box. [5]

4. physics

At a construction site a pipe wrench struck the ground with a speed of 24 m/s. (a) From what height was it inadvertently dropped? (b) How long was it falling?

1. Math

A construction crew wants to hoist a heavy beam so that it is standing up straight. They tie a rope to the beam, secure the base, and pull the rope through a pulley to raise one end of the beam from the ground. When the beam makes

2. physics

At a construction site a pipe wrench struck the ground with a speed of 45 m/s. (a) From what height was it inadvertently dropped? (b) How long was it falling?

3. Geometry

A construction crew wants to hoist a heavy beam so that it is standing up straight. They tie a rope to the beam, secure the base, and pull the rope through a pulley to raise one end of the beam from the ground. When the beam makes

4. college

The arm in the figure below weighs 44.5 N. The force of gravity acting on the arm acts through point A. Determine the magnitudes of the tension force t in the deltoid muscle and the force s of the shoulder on the humerus

1. Physics

a modified U-tube: the right arm is shorter than the left arm. The open end of the right arm is height d = 10.0 cm above the laboratory bench. The radius throughout the tube is 1.60 cm. Water is gradually poured into the open end

2. physics

a modified U-tube: the right arm is shorter than the left arm. The open end of the right arm is height d = 10.0 cm above the laboratory bench. The radius throughout the tube is 1.60 cm. Water is gradually poured into the open end

3. Physics

A giant swing at a county fair consists of a vertical central shaft with a number of horizontal arms attahed at its upper end. Each arm supports a seat suspended from a 5.00 m long rod, the upper end of which is fastened to the