physics

A flywheel with a diameter of 1 m is initially at rest. Its angular acceleration versus time is graphed in the figure.

(a) What is the angular separation between the initial position of a fixed point on the rim of the flywheel and the point's position 8 s after the wheel starts rotating? (Be sure to give angular separation rather than total angular displacement.)

(b) The point starts its motion at è = 0. Calculate the linear position 8 s after the wheel starts rotating. (Let the initial position of the point be 0.5 .)
m

Calculate the linear velocity vector 8 s after the wheel starts rotating. (Enter the magnitude.)

Calculate the tangential acceleration vector after the wheel starts rotating. (Enter the magnitude.)

  1. 👍 0
  2. 👎 0
  3. 👁 325
  1. We can't see your figure. There is no point posting such questions here.

    1. 👍 0
    2. 👎 0

Respond to this Question

First Name

Your Response

Similar Questions

  1. physics

    A flywheel of moment of inertia 0.32 kgm^2 is rotated steadily at 120rad/s by a 50 W electric motor. (i)find the kinetic energy and angular momentum of the flywheel. (ii) calculate the value of frictional couple opposing the

  2. Physics please help! check if its correct

    A 3.00 kg stone is tied to a thin, light wire wrapped around the outer edge of the uniform 8.00 kg cylindrical pulley. The inner diameter of the pulley is 60.0 cm, while the outer diameter is 1.00 m. The system is released from

  3. Physics

    A ruler is initially at rest when a student briefly exerts a downward force on the right end. The magnitude of the force exerted by the student is less than the weight of the ruler. Assume that the pivot point in the center of the

  4. Physics

    A wheel starts rotating from rest with uniform angular acceleration.After 3.0,its completes one revolution.Calculate a) angular velocity after 3.0s. b)angular acceleration c)angular velocity after completing d)time taken for

  1. Physics

    Starting from rest, a disk rotates about its central axis with constant angular acceleration. In 6.00 s, it rotates 28.0 rad. During that time, what are the magnitudes of (a) the angular acceleration and (b) the average angular

  2. physics

    A flywheel with an axle 1.0cm in diameter is mounted in frictionless bearings and set in motion by applying a steady tension of 2N to a thin thread wound tightly round the axle. The moment of inertia of the system about its axis

  3. physics

    The drawing shows a top view of a square box lying on a frictionless floor. Three forces, which are drawn to scale, act on the box. Consider an angular acceleration with respect to an axis through the center of the box

  4. Physics

    A passenger bus in Zurich, Switzerland derived its motive power from the energy stored in a large flywheel. The wheel was brought up to speed periodically, when the bus stopped at a station, by an electric motor, which could then

  1. Physics

    A wheel starts from rest and rotates about its axis with constant angular acceleration. After 8.7 s have elapsed, it has rotated through an angle of 20 radians. I found that the angular velocity at 8.7 s is 4.60 rad/s. What is the

  2. physics

    help please?? A bocce ball with a diameter of 6.00 cm rolls without slipping on a level lawn. It has an initial angular speed of 2.35 rad/s and comes to rest after 2.50 m. Assuming constant deceleration, determine (a) the

  3. physic

    In an experiment, a mass m = 40 gm, attached to a string wrapped around the axle of a flywheel and starting from rest, falls through a distance of 147 cm in 3.5 seconds. The diameter of the axle of the flywheel is 12 cm What is

  4. Angular acceleration

    A flywheel of 480 mm diameter is accelerated with an angular velocity of 0.4 rad/s^-2 from rest by an electric motor until it is rotating at 400 revs/minute. Calculate: a) the time of acceleration b) the linear speed of the rim of

You can view more similar questions or ask a new question.