Respond to this Question
Similar Questions

Math
A length of metal pipe has a circumference of 2.5 inches. the pipe is 1/16 inches thick. a gas fitter needs to know the inside diameter of the pipe to calculate the gas pressure. What is the total diameter of pipe including metal? 
math
The outside diameter of a pipe is 5 and 7/32 inches. The walls of the pipe are 5/32 inches thick. find the inside diameter 
Statistics
The inside diameter of the automobile wheel bearing sets at a factory is expected to be normally distributed with a mean of 1.30inches and a standard deviation of 0.04 inches. What is the probability that a randomly selected wheel 
math
The diameter of a pipe is normally distributed with a mean of 0.4 inches and a variance of 0.0004. What is the probability that the diameter of a randomly selected pipe will exceed 0.44 inches? 
math
The diameter of a pipe is normally distributed with a mean of 0.4 inches and a variance of 0.0004. What is the probability that the diameter of a randomly selected pipe will exceed 0.44 inches? 
For Ms Sue
Claim: the lateral (side ) surface of any area of any cylinder can is larger than the circlar surface area of its bottom. Which of the following is an example showing that the claim is false? a. a can with the diameter of 5 inches 
geometry need help
Claim: the lateral (side ) surface of any area of any cylinder can is larger than the circlar surface area of its bottom. Which of the following is an example showing that the claim is false? a. a can with the diameter of 5 inches 
Physics
A horizontal water pipe goes from a large diameter to a small diameter and then back to the first diameter as shown in the figure below. The level of water (8cm in the larger tube and 4 cm in the constricted tube) in the small 
math
A cross section of a hollow circular pipe shows that its inner diameter is 2 1/10 inches and that the pipe is 3/5 inch thick. What is its outside diameter? 
STAT
The inside diameter of a manufactured cylinder is believed to follow a normal distribution centered at 5.00 inches with standard deviation of .03 inches. The diameter of the cylinder must be within 4.95 inches (the lower