A monatomic ideal gas expands from point A to point B along the path shown in the drawing.

(a) Determine the work done by the gas.
J

(b) The temperature of the gas at point A is 198 K. What is its temperature at point B?
K

(c) How much heat has been added to the gas during the process? (This will be a negative number if heat has been removed from the gas.)

this is the picture C:\Users\josh\Desktop\p15-24.gif

1. 👍 0
2. 👎 0
3. 👁 287

## Similar Questions

1. ### thermal heat

Consider the following. (a) Find the work done by an ideal gas as it expands from point A to point B along the path shown in the figure. MJ (b) How much work is done by the gas if it compressed from B to A along the same path? MJ

asked by Annette on April 29, 2013
2. ### Physics

Suppose a monatomic ideal gas is changed from state A to state D by one of the processes shown on the PV diagram. Find the total work done on the gas if it follows the constant temperature path A-C followed by the constant

asked by Dan on December 6, 2010
3. ### Physics

A monatomic ideal gas expands from 1.00m^3 to 2.50m^3 st a constant pressure of 2.00x10^5 Pa. Find the change in the internal energy of the gas.

asked by B on November 24, 2012
4. ### Physics

A monatomic ideal gas expands from 1.00m^3 to 2.50m^3 st a constant pressure of 2.00x10^5 Pa. Find the change in the internal energy of the gas.

asked by S on November 22, 2012
5. ### Physics

A monatomic ideal gas expands from 1.00m^3 to 2.50m^3 st a constant pressure of 2.00x10^5 Pa. Find the change in the internal energy of the gas.

asked by A on November 23, 2012
6. ### Physics

A monatomic ideal gas expands from 1.00m^3 to 2.50m^3 st a constant pressure of 2.00x10^5 Pa. Find the change in the internal energy of the gas.

asked by A on November 22, 2012
7. ### physics

We start with 5.00 moles of an ideal monatomic gas with an initial temperature of 123C. The gas expands and, in the process, absorbs an amount of heat equal to 1300J and does an amount of work equal to 2040J. What is the final

asked by Annie on October 4, 2009
8. ### Physics

A heat engine using a monatomic gas follows the cycle shown in the pV diagram to the right. The gas starts out at point 1 with a volume of 233 cm3, a pressure of 235 kPa, and a temperature of 317 K. The gas is held at a constant

asked by Bob on April 22, 2019
9. ### Physics

A tank with a constant volume of 3.44 m3 contains 14 moles of a monatomic ideal gas. The gas is initially at a temperature of 300 K. An electric heater is used to transfer 52600 J of energy into the gas. It may help you to recall

asked by Leul on February 9, 2016
10. ### Physics

A heat engine carries 2.60 mol of an ideal monatomic gas around the cycle shown in the figure. Process 1-2 takes place at constant volume and takes the gas from 300 K to 600 K, process 2-3 is adiabatic and takes the gas from 600 K

asked by Anonymous on April 19, 2015

More Similar Questions