Physics
 👍
 👎
 👁
Respond to this Question
Similar Questions

Circuits, Kirchoff
A circuit can be used to measure the resistance of a platinum resistance thermometer (PRT). AB is a uniform resistance wire of length 1.0mandCisa sliding contact on this wire. A standard resistor R is included in the circuit. The

physics
A light rigid bar is suspended horizontally from two vertical wires, one of steel and one of brass. Each wire is 2.00m long. The diameter of the steel wire is 0.60mm and the length of the bar AB is 0.20m. When a mass of 10.0kg is

Physics
What is the diameter of a 1.00 meter length of tungsten wire whose resistance is 0.32 ohm (electrical resistance)?

Physics
Two wires are identical, except that one is aluminum and one is copper. The aluminum wire has a resistance of 0.835. What is the resistance of the copper wire? Take the resistivity of copper to be 1.72 x 108 Ω·m, and that of

physical science
The heating elements of an electric toaster is typically made of nichrome wire (an alloy of nickel and chromium). As current passes through the wires, the wires heat up, thus toasting the toast. Estimate the overall resistance of

Algebra II
If 750 m of 3.00mmdiameter wire has a resistance of 27.6, what length of similar wire 5.00 mm in diameter will have the same resistance?

physics
Consider two copper wires with the same crosssectional area. Wire A is twice as long as wire B. How do the resistivities and resistances of the two wires compare? CHECK ALL THAT APPLY Wire A and wire B have the same resistance.

Physics
A 550 turn solenoid is 15 cm long. The current in it is 33 A. A 3.0 cm long straight wire cuts through the center of the solenoid, along a diameter. This wire carries a 22 A current downward( and is connected by other wires that

physics
1. Two identical 15.0 kg balls, each 25.0 cm in diameter, are suspended by two 35.0 cm wires as shown in the figure. The entire apparatus is supported by a single 18.0 cm wire, and the surfaces of the balls are perfectly smooth.

physics
im confused... how should i solve this when there is no resistivity value given? The resistance of a rod with a length of 3.0 m and diameter of 1.0 cm is 56.0 ohms. If this rod is stretch to form a wire with a diameter of 0.01 cm,

Physics resistance question
A piece of copper wire of resistance R is cut into 10 equal lengths. These parts are connected in parallel. How does the joint resistance of the parallel combination compare with the original resistance of the single wire?

Math
Two wires are connected to a tower at the same point on the tower. Wire 1 makes an angle of 45° with the ground and wire 2 makes an angle of 60° with the ground. b) Which wire is longer? Explain. (2 marks) c) If the point where
You can view more similar questions or ask a new question.