electricity

if a bar of copper is brought near a magnet, the copper bar will be? A)attracted by the magnet. B)unaffected by the magnet. C)repelled by the magnet. D)made into an induced magnet.


B)unaffected by the magnet.

Actually there is a very slight repulsn due to diamagnetism (C), but they probably don't expect you to know that.


the bar is unaffected by the magnet


D made into an induced magnet


If a bar of copper is brought neat a magnet, the copper bar will be?

  1. 👍 0
  2. 👎 0
  3. 👁 223
asked by angela
  1. unaffected by the magnet

    1. 👍 0
    2. 👎 0

Respond to this Question

First Name

Your Response

Similar Questions

  1. science

    if a bar of copper is brought near a magnet, the copper bar will be not magnetic, nonferrous, not attracted to the magnet, etc

    asked by rita on October 8, 2006
  2. physics- answers check

    1. For a bar magnet, the magnetic field lines point a. towards the South pole. b. towards the North pole. c. always towards the magnet. d. always away from the magnet. my answer: a 2. Magnetic field lines a. are straight lines. b.

    asked by Liz on May 10, 2014
  3. physics

    A compound metal bar has 4 kg of copper making up the first third of the bar, while the remainder is made of 12 kg of lead. The bar is 3 meters in length. In addition, a mass of 2 kg is hung 1m from the left end of the bar, and a

    asked by tyger2020 on December 5, 2018
  4. Physics

    A "Bus" bar is in the form of a slab of copper 2meters long, 1cm wide, and 10 cm thick. a) What is the resistance of the bar at 0 degrees celcius? b) What potential difference is needed to push 5000 amps through the bar?

    asked by Tristan on May 16, 2010
  5. electromagnetism

    Two identical bar magnets A and B are held at rest as shown and released to fall simultaneously. Magnet A as it falls passes through the center of a copper ring, magnet B does not. #9 (4 points possible) Which of the following

    asked by JuanPro on April 14, 2015
  6. strength of materials

    The composite bar BCD in the figure is fixed at the wall B (x=0), and has constant cross sectional area A_0. The bar is composed by joining, at section C, two segments (BC and CD) of equal length L. Segment CD is homogeneous, made

    asked by ashwni on July 17, 2016
  7. Physics

    The composite bar BCD in the figure is fixed at the wall B (x=0), and has constant cross sectional area A_0. The bar is composed by joining, at section C, two segments (BC and CD) of equal length L. Segment CD is homogeneous, made

    asked by skrillex on July 17, 2016
  8. science

    When 90 kJ is removed from a 2-kg copper bar, its temperature drops from 200°C to 85°C. The specific heat of copper is

    asked by Anonymous on October 14, 2014
  9. Physics

    The substation bus bar is made up of 2-iches round copper bars 20 ft. long. What is the resistance of each bar if resistivity is 1.724 x 10-6 ohm-cm.

    asked by Jhun on September 25, 2015
  10. Physics mit 2.01x

    F13Q1_1: COMPOSITE BAR UNDER DISTRIBUTED LOADING The composite bar AB has length L and is fixed at A(x=0). The bar has a constant cross-section and is composed of two steel plates, of modulus Es=2E0 sandwiching a copper core of

    asked by Michael on July 15, 2014

More Similar Questions