# bio/chem

how do i make percent solutions w/v starting with pure NaCl and distill water. eg 100ml of a 1% NaCl solution

1. 👍 0
2. 👎 0
3. 👁 70
1. 1 g NaCl in 100 mL total volume distilled water.

1. 👍 0
2. 👎 0

## Similar Questions

1. ### Chemistry

had to perform an experiment for the freezing point depression in which we had to determine the frezzing points of water as a pure solvent, sodium chloride, sucrose, and ethylene glycol. We had to work with a partner so I

asked by Hannah on February 20, 2012
2. ### chemisrty

Q4) Suppose you prepare 950 mL of a solution by dissolving 100 grams of NaCl in 900 mL of water. Assuming the density of pure water to be 1 g/mL, answer the following questions with regards to this solution: a) What is the mass

asked by lyan on January 16, 2012
3. ### Chemistry

Determine the number of moles of NaCl in the solution. Measured Mass of NaCl: 11.69g Measured Vol of Water: 100mL Molar Mass of NaCL: 58.44g/mol 11.69gNaCL/58.44g/mol = 0.20 mol NaCl Do I then to multiply my answer by 100ml? 0.20

asked by Rose on March 16, 2017
4. ### chemistry

About how much should the boiling point of pure water differ from .5m 1m and 1.5m aqueous solutions of NaCl and same molal solutions of CaCl2 Trying to check experimental data from van't hoff factor lab

asked by bob on June 4, 2011
5. ### CHEMISTRY

The solubility of a compound in water is 6.8g/100ml at 0.33g/100ml at 25 degree celsius. Calculate the amount of water required to crystallise 10g of the compound. If the pure compound is collected at 25 degree celsius, what is

asked by VICKI on February 16, 2013
6. ### Chemistry

To 1.0 ml of 1.5%NaCl, water is added to a final volume of 100ml. What is the molarity NaCl of this final solution? 1.5g/100ml I do not know where to go from here?

asked by Samantha on November 30, 2014
7. ### Science

The solubility of a compound in water is 6.8g/100ml at 25°C.. Calculate the amount of water required to crystallize 10g of the compound. If the pure compound is collected at 25°C what is the maximum possible yield percent.

asked by Charles on September 21, 2015
8. ### chemistry

The solubility of a compound in water is 6.8g/100ml at 25°C. Calculate the amount of water required to crystallise 10g of the compound. If the pure compound is collected at 25°C what is the maximum possible yield percent?

asked by Amas on December 29, 2015
9. ### Chemistry

How many grams of NaCl are neeeded to make 100ml of a 2M solution of NaCl

asked by corinna on July 13, 2011
10. ### Chemistry

If there were two solutions- one with areagent(100% pure) mixed in water and the other solution containing the same reagent (99.9% pure) mixed in equal volume of water. How significant would the difference in concentration be

asked by Andrew on March 29, 2010

More Similar Questions