Chemistry

What is the pH when 0.40 g of NaOH is added to 50,0 mL of 0.10 M HCOOH? No volume change. (Ka for HCOOH - 1.8 x 10^-4.)

1. 👍
2. 👎
3. 👁
1. Convert 0.40 g NaOH to moles.
Convert 50.0 mL x 0.1 M HCOOH to moles.
See which is in excess. If NaOH, then calculate pOH and pH.
If HCOOH, it will be a buffer and you should use the Henderson-Hasselbalch equation.

1. 👍
2. 👎

Similar Questions

1. Chemistry

1.What is the pH of a solution containing 0.042 M NaH2PO4 and 0.058 M Na2HPO4 ? The pKa of sodium phosphate is 6.86. pH = 6.86 + log [0.058] / [0.042]; pH = 6.86 + 0.14; pH = 7.00 That is my answer to the above question. The

2. Chemistry

Suppose NaOH is added to the following system when it is at equilibrium. NH3 (aq) + H2O (l) = NH4 (aq) + OH (aq) a) in which direction will the reaction shift after the NaOH is added? b) will this stress increase or decrease the

3. Chemistry

When a diprotic acid, H2A, is titrated by NaOH, the protons on the diprotic acid are generally removed one at a time, resulting in a pH curve that has the following generic shape. (a) Notice that the plot has essentially two

4. Chem 2

5 drops of 0.10M NaOH were added to 20mL of the buffer problem, the pHwent from 3.40 to 3.43. Write a net ionic equiation to explain why the pH did not go up to about 10, as it would have if that amount of NaOH were added to

1. AP Chemistry

help with acid/bases If the pH at 50.0 mL of NaOH added is 4.0 and the pH at 150.0 mL of NaOH added is 8.0, determine the values Ka1 and Ka2 for the diprotic acid. Ka1 i dotn know how to start, please help!

2. chemistry

A volume of 100mL of 1.00 M HCl solution is titrated with 1.00 M NaOH solution. You added the following quantities of 1.00 M NaOH to the reaction flask. Classify the following conditions based on whether they are before the

3. acid-base titrations

For each of the following circumstances, indicate whether the calculated molarity of NaOH would be lower, higher or unaffected. Explain your answer in each case. a.the inside of the pipet used to transfer the standard HCI solution

4. CHEMISTRY FOR DR. BOB or anyone else

A hypothetical weak acid HA, was combined with NaOH in the following proportions: 0.20 mol HA, 0.08 mol NaOH. The mixture was then diluted to a total volume of 1L, and the pH measured. (a) If pH=4.80, what is the pKa of the acid

1. chemistry

calculate the mass of NaOH neded to prepare 500mL of a 0.10 M solution. I'm pretty sure the answer is 2g, but how do I get to that? Another question: calculate the molar amount of KHP used to neutralize the NaOH solution. .51 g of

2. Org. Chem.

what is the precipitate formed when HCl is added? I believe the answer is NaCl, but I am not sure and this precipitate only formed in the first NaOH extract, as precipitate was essentially nonexistent in the 2nd extract? Below is

3. chemistry

In a titration, NaOH was added to a burette. The initial reading was 1.2 ml. At the end of the titration, the final reading was 24.8 ml. What was the volume of NaOH that was added?

4. Chemistry

In one trial of an investigation 50.0 mL of HCl(aq) of an unknown concentration is Tiresias with 0.10M NaOH (aq). During the titration the total volume of NaOH (aq) added and corresponding pH value of the reaction mixture are