# Physics

At t = 0, a wheel rotating about a fixed axis at a constant angular acceleration of –0.40 rad/s^2 has an angular velocity of 1.5 rad/s and an angular position of 2.3 rad. What is the angular position of the wheel
at t = 2.0 s? Ans: Theta final=4.5 rad
How do you solve step by step. Thanks
Does this look correct below?
Of = Oi+Wi*t+1/2*a*t^2
Thanks! Bob Pursley, This helped me solve it and here is the step by step break down.

1. 👍
2. 👎
3. 👁

## Similar Questions

1. ### Physics

A particular Ferris wheel (a rigid wheel rotating in a vertical plane about a horizontal axis) at a local carnival has a radius of 20.0 m and it completes 1 revolution in 9.84 seconds. (a) What is the speed (m/s) of a point on the

2. ### physics

The flywheel of a steam engine begins to rotate from rest with a constant angular acceleration of 1.45 rad/s2. It accelerates for 29.5 s, then maintains a constant angular velocity. Calculate the total angle through which the

3. ### Physics 1 (Calc Based)

At t = 0, a wheel rotating about a fixed axis at a constant angular acceleration of –0.40 rad/s^2 has an angular velocity of 1.5 rad/s and an angular position of 2.3 rad. What is the angular position of the wheel at t = 2.0 s?

4. ### Physics

An electric motor rotating a workshop grinding wheel at a rate of 95 rev/min is switched off. Assume the wheel has a constant negative angular acceleration of magnitude 2.40 rad/s2. (a) How long does it take for the grinding wheel

1. ### Physics

Two objects of equal mass are on a turning wheel. Mass 1 is located at the rim of the wheel while mass 2 is located halfway between the rim and the axis of rotation. The wheel is rotating with a non-zero angular acceleration. For

2. ### Physics

The blades of a ceiling fan have a radius of 0.348 m and are rotating about a fixed axis with an angular velocity of +1.63 rad/s. When the switch on the fan is turned to a higher speed, the blades acquire an angular acceleration

3. ### physics

A flywheel with a diameter of 1 m is initially at rest. Its angular acceleration versus time is graphed in the figure. (a) What is the angular separation between the initial position of a fixed point on the rim of the flywheel and

4. ### Physics

A wheel of radius R starts from rest and accelerates with a constant angular acceleration alpha about a fixed axis. At what time t, will the centripetal and tangential accelerations of a point on the rim have the same magnitude?

1. ### physics

When a wheel of radius R rotates about a fixed axis, do all points on the wheel have 1) The same angular velocity? Explain. 2) The same linear velocity? Explain. If the angular velocity is constant, 3) describe the linear

2. ### physics

A rotating wheel requires 7.00 s to rotate 28.0 revolutions. Its angular velocity at the end of the 7.00-s interval is 97.0 rad/s. What is the constant angular acceleration (in rad/s) of the wheel? rad/s2

3. ### Physics

A wheel starts rotating from rest with uniform angular acceleration.After 3.0,its completes one revolution.Calculate a) angular velocity after 3.0s. b)angular acceleration c)angular velocity after completing d)time taken for

4. ### physics

A typical ten-pound car wheel has a moment of inertia of about 0.35 kg*m^2. The wheel rotates about the axle at a constant angular speed making 45.0 full revolutions in a time interval of 7.00 sec . What is the rotational kinetic