Chemistry

Steel plate is in contact with copper. Give the scheme of electrochemical corrosion in natural and acidic medium and write the equations for the reactions that occur.

  1. 👍
  2. 👎
  3. 👁

Respond to this Question

First Name

Your Response

Similar Questions

  1. MATH - HELP ME PLEASE!!!!

    A steel plate has the form of one-fourth of a circle with a radius of 42 centimeters. Two two-centimeter holes are to be drilled in the plate positioned as shown in the figure in the website. Find the coordinates of the center of

  2. chemistry

    copper compounds such as copper (II) sulfate are toxic. before disposal, these compounds must be treated to reduce their toxicity. describe how to use steel wool to remove the Cu 2+ ions from an aqueous solution of copper (II)

  3. physics

    a horizontal plate is vibrating vertically with simple harmonic motion at a frequency of 20 Hz.What is the amplitude of vibration so that the fine sand on the plate always remain in contact with it?

  4. Physics

    A m1 = 1.95-kg aluminum block and a m2 = 7.85-kg copper block are connected by a light string over a frictionless pulley. The two blocks are allowed to move on a fixed steel block wedge (of angle 𝜃 = 34.0°) as shown in the

  1. science

    a cylinder of diameter 1cm at 30 degrees celcius is to be slid into a steel plate. the hole has a diameter 0.9997cm at 30 degrees celcius. to what temperature must the plate be heated? for steel

  2. Physics

    This is an Oscillations question. A horizontal plate is vibrating vertically in simple harmonic motion at a frequency of 20Hz. What is the maximum amplitude of vibration so that a coin of 0.0080kg resting on the plate always

  3. Science

    If you scratch a penny with an steel file, will the copper of the penny rub off on the file, or the steel (iron) of the file rub off on the penny? 12. What can we determine from the above experiment about the relative hardness of

  4. physics

    A trajectile, of mass 20 g, traveling at 350 m/s, strikes a steel plate at an angle of 30-degrees with a plane of the plate. It ricochets off at the same angle, at a speed of 320 m/s. What is the magnitude of the impulse that the

  1. physics

    A commonly used method of fastening one part to another part is called "shrink fitting." A steel rod has a diameter of 2.0046 cm, and a flat plate contains a hole whose diameter is 2.0000 cm. The rod is cooled so that it just fits

  2. physics

    Comic-book superheroes are sometimes able to punch holes through steel walls. (a) If the ultimate shear strength of steel is taken to be 3.00 x 10^9 Pa, what force is required to punch through a steel plate 1.90 cm thick? Assume

  3. Science

    A bullet of mass 20g, travelling at a speed of 350m/s, strikes a steel plate at an angle of 30° with the plane of the plate. It ricochet off at the same angle at a speed of 320m/s. What is the magnitude of the impulse that the

  4. physics

    a crane drops a .3 kg steel ball onto a steel plate. the ball's speeds just before impact and after are 4.5 m/s and 4.2 m/s respectively. If the ball is in contact with the plate for .03 s, what is the magnitude of the average

You can view more similar questions or ask a new question.