Questions LLC
Login
or
Sign Up
Ask a New Question
Science
Physics
determine the velocity of a charge that push by the 16 volts source
1 answer
energy = q V = 16 q
so
(1/2) m v^2 = 16 q
You can
ask a new question
or
answer this question
.
Similar Questions
A charge q=+5.11 mC (millicoulombs) has a mass of 0.00456 kg and is accelerated by two rings connected to a voltage source of
Top answer:
ℰ=Δφ=1378 V mv²/2=qΔφ v=sqrt(2qΔφ/m)=…
Read more.
Determine the concentration (in M ) of lead ions
Pb^2+ e= -0.13 volts M=? Ni^2+ e=-.25 volts Ni^2 M=.27M e=-0.020 volts
Top answer:
Pb(s) Pb^2+ (aq) [pb^2+] =?M Ni^2+(aq) Ni^2+=.27M Ni(s) Pb^2+ +2e^- Pb E= -0.13v Ni^2+ +2e^- Ni
Read more.
How many volts would be needed to produce a current of 8 amps in a 6 ohm resistor?
a 24 volts b 48 volts c 1.3 volts d 12 volts
Top answer:
AAAaannndd the bot gets it wrong yet again! E = IR = 8*6 = 48 V so, B
Read more.
How many volts would be needed to produce a current of 8 amps in a 6 ohm resistor?
a 12 volts b 1.3 volts c 48 volts d 24 volts
Top answer:
no, it's 48. Took the schoology final and that is just really easy.
Read more.
How many volts would be needed to produce a current of 8 amps in a 6 ohm resistor?
a 12 volts b 24 volts c 48 volts d 1.3 volts
Top answer:
b) 48 volts
Read more.
With an input of 3600 volts, and a turns ratio of 30:1, what is the output voltage of this transformer? Select the correct
Top answer:
120 volts
Read more.
Four identical bulbs are set up in a series circuit with an 8V battery. The voltage across each bulb is
A 8 volts. B 2 (8 ÷ 4)
Top answer:
B 2 (8 ÷ 4) volts.
Read more.
A records voltages from 0 volts to 20 volts. If the average value for three readings on the meter was 16 volts, then what the
Top answer:
since the largest reading is 20, you have x+20+20 = 3*16 x = 8 for the smallest.
Read more.
Consider a transformer with a primary that has 50 turns of wire and a secondary of 250 turns. Then a 110-V input will produce an
Top answer:
A). The turns ratio equals the voltage ratio.
Read more.
You have an RC circuit and you measure the "zero" voltage to actually be 2.385 [Volts].
The peak voltage is measured to be 8.262
Top answer:
To find the voltage value at t4 for 15/16 total charge in an RC circuit, we need to calculate the
Read more.
Related Questions
The test charge is 12 mm from Q1 and 20 mm from Q2. If Q1 has a relative charge of +4e and Q2 has a relative charge of +8e
A 15-volt power supply is used to power a circuit with two resistors in series. The voltage drop across R1 is 5 volts. What is
A small sphere of mass m and charge +q with zero velocity falls under the influence of gravity (acceleration = g from height h
A charge with a value of 3.0 x 10-5 C is located 2.5 cm from a charge with a value of 6.5 x 10-5 C. Determine the distance from
1. Which of the following question should you ask to help determine the suitability of a source?
A Who is the source's audience B
A block weighing 8.3 N requires a force of 2.6 N to push it along at constant velocity. What is the coefficient of friction
Study Source 1 and Source 2 below and answer the questions that follow:
Source 1: Source 2: Based on what you have learnt about
In a science fiction novel two enemies, Bonzo and Ender, are fighting in outer spce. From stationary positions, they push
A Baseball player leads off the game and hits along home run. The ball leaves the bat at an angle of 30° with a velocity of 70
What characteristics make a source credible? Select all that apply.
* 4 points A source that is current A source on social media