Chemistry

If air has an average density of 1.29 g/l and Co is reported at 2.0 ppm, what volume of air will contain 1.00 mole of Co?

There will have to be 1/(2*10^-6) = 500,000 times as much mass of air as CO. The mass of the CO is 28.0 g (1.00 mole), so that requires 14*10^6 g or air. Divided that by the density (1.29 g/l) for the volume in liters.

  1. 👍 0
  2. 👎 0
  3. 👁 159
asked by nancy

Respond to this Question

First Name

Your Response

Similar Questions

  1. chemistry

    if air has an average density of 1.29 g/L and CO is reported at 2.0 ppm, what volume of air will contain 1.00 mol of CO ?

    asked by loha on April 6, 2013
  2. Chemistry

    Sea water contains an average of 270 ppm of sulfate ion. Calculate the molar concentration of sulfate given that the average density of sea water is 1.02 g/ml. -At first i tried assuming that density is 1.00 g/ml which is a common

    asked by xavier on June 12, 2013
  3. science

    The following replicate values were reported for the concentration of magnesium chloride, MgCl2, in mol/L. What value should be reported as the mean concentration of the chloride ion, Cl, converted to ppm? (You may use the

    asked by Lo on October 5, 2016
  4. Chemistry

    The following replicate values were reported for the concentration of magnesium chloride, MgCl2, in mol/L. What value should be reported as the mean concentration of the chloride ion, Cl-, converted to ppm? (You may use the

    asked by Mr. J on October 4, 2016
  5. Chemistry

    The Label on a one pint bottle of water lists the following components. If the density is the same as pure water and you drink 3 bottles of water in one day, how many milligrams of each component will you obtain? 1) calcium 29 ppm

    asked by Susan on September 7, 2008
  6. Chemistry

    I have a certain concentration of NaCl (in mg/L). I have to convert it to ppm Na+. I read some of the previous posts, and I understand that if I don't know the density, I should assume that 1ppm = 1mg/L. Does this also apply to

    asked by Maggie on February 20, 2007
  7. Chemistry

    The Label on a one pint bottle of water lists the following components. If the density is the same as pure water and you drink 3 bottles of water in one day, how many milligrams of each component will you obtain? 1) calcium 29 ppm

    asked by Susan on September 7, 2008
  8. Chemistry -Dr.Bob

    Toxic chemicals in drinking water usually are reported and a safety level specified in units of parts per million (ppm) by mass. What is the molar concentration of arsenic in a water sample that has 1ppm arsenic (As)? DrBob222 1

    asked by Tiffany on October 25, 2015
  9. chemistry

    The mole fraction of neon in the air is about .0000026. If the average molar mass of air is 28.96 g/mol, what is the concentration of neon in air in ppm? How do you set this up?

    asked by Sarah on November 2, 2014
  10. Chemistry

    Hardness is defined as calcium and magnesium ion content. Since most hardness is caused by carbonate mineral deposits and does not distinguish calcium and magnesium ions, hardness is usually reported as parts per million (ppm) of

    asked by KO on January 19, 2017

More Similar Questions