# chemistry

A solution of HCI has a density of 1.18 g/ml and is 36% (m/m). what is the molarity and molality of this solution?

Assume 100g solution. Then the solute is 36 grams. Figure the moles for that.

Then, you know density, so you can compute volume (100g/density)

Molarity= moles solute/liters solution

molality= moles solute/kg solvent

1. 👍
2. 👎
3. 👁

## Similar Questions

1. ### acid-base titrations

For each of the following circumstances, indicate whether the calculated molarity of NaOH would be lower, higher or unaffected. Explain your answer in each case. a.the inside of the pipet used to transfer the standard HCI solution

2. ### Chemistry

If it takes 54 mL of 0.1 M NaOH to neutralize 125 mL of an HCI solution, what is the concentration of the HCI?

3. ### Chem

Which of the following is weak electrolyte in solution -H2S -H2SO4 -HI - HNO3 - HCI

4. ### chem 2

which one of the following pairs of 0.100 mol L-1 solutions, when mixed will produce a buffer solution? a 50. mL of aquesous CH3COOH and 25.mL of aquesous HCI b 50. mL of quesous CH3COOH and 100. mL of aqueous NaOH c 50. mL of

1. ### chem

what is the molality of a solution of 50.0 grams of propanol in 152 mL water if the density of wate is 1.0 g/mL and the density of the solution is 0.78 g/mL

2. ### chemistry

A glucose solution contains 55.8g of glucose (C6H12O6) in 455g of water. Calculate the freezing poing and boiling point of the solution. (Assume a density of 1.00 g/ml for water. This what I did, I got moles of C6H12O6, 0.89 moles

3. ### Chemistry

The density of table salt is 2.16 g/cm3. Detail the conversion into units of pounds per liter, and provide the density in lb/L. My solution must include a step-by-step solution with units included throughout!

4. ### Chemistry

calculate the pH and the pOH of an aqueous solution that is 0.035 M In HCI and 0.080 M in HBr?

1. ### CHEMISTRY

An ethanol-water solution is prepared by dissolving 10.00 ml ethanol C2H5OH (density=0.789g/ml) in sufficient water to produce 100.00 ml of solution with a density of 0.982g/ml. What is the concentration of ethanol in this

2. ### chromatography

so we did this lab on chromatography, and in the beaker was 10 mL of HCI and 35 mL of acetone. IF the distilled water used to prepare the HCI solution in this experiment passed through iron pipes, then the HCI will be contaminated

3. ### Describe how you would make 250 mL of 0.500 M HCI

Describe how you would make 250 mL of 0.500 M HCI from 12.1 M HCI. Show calculations.

4. ### Chemistry

The density of acetonitrile (CH3CN) is 0.786g /mL and the density of methanol (CH3OH) is 0.791g/mL. A solution is made by dissolving 22.5 mL of CH3OH in 98.7 mL of CH3CN . (a) What is the mole fraction of methanol in the solution?