Science

If a brake system fails due to lack of fluid, is the lack of fluid a basic, primary, or secondary event in a fault tree analysis?

It could be primary, however, usually, it would be secondary, the primary failure being a ruptured hose or O ring.

Thanks!

  1. 👍
  2. 👎
  3. 👁

Respond to this Question

First Name

Your Response

Similar Questions

  1. Math

    1. A box of crackers has 24 grams of fat. the box contain 8 servings. What is the unit rate? A. 16 grams of fat pre serving B. 8 grams of fat per serving C. 4 grams of fat per serving D. 3 grams of fat per serving 2. A 16-fluid

  2. Language Arts

    Which of the following is likely to cause lethargy? A.too little food B.bad weather C.lack of sleep D.a lack of heat

  3. physicss

    An ideal fluid flows through a pipe made of two sections with diameters of 1.0 and 3.0 inches, respectively. What is the ratio of the speed of the fluid through the 3.0-inch section to the speed of the fluid through the 1.0-inch

  4. Physics

    The patient in the figure below is to receive an intravenous injection of medication. In order to work properly, the pressure of fluid containing the medication must be 108 kPa at the injection point. (a) If the fluid has a

  1. Physics

    An incompressible fluid is flowing through a horizontal pipe with a constriction. The velocity of the fluid in the wide section of the pipe is 4.00 m/s and the velocity of the fluid in the narrow section of pipe is 9.00 m/s. The

  2. physics

    why does an ideal fluid move faster through a pipe with decreasing diameter? a. the pressure within the fluid increases b. the pressure within the fluid decreases c. the pipe exerts more pressure on the fluid d. the fluid moves

  3. Physics

    I can't seem to figure out this problem...what equation would I use? Thanks! An incompressible, nonviscous fluid is initially at rest in the vertical portion of the pipe, where L = 2.17 m. When the valve is opened, the fluid flows

  4. science

    The pressure on a fluid at rest in a pipe increases by 20 Pa. How does this change in pressure affect the pressure on the fluid in the rest of the pipe? 1. The pressure in the rest of the fluid stays the same because the pressure

  1. math

    A market research survey conducted by Company-Check was looking at the reason why small businesses fail. From a group of 84 businesses that failed they discovered the following: 41 failed because of a lack of funds; 36 failed

  2. physics

    why does an ideal fluid move faster through a pipe with decreasing diameter? a. the pressure within the fluid increases b. the pressure within the fluid decreases c. the pipe exerts more pressure on the fluid d. the fluid moves

  3. Physics

    When a person is given intravenous fluid, the bag containing the fluid is typically held about 1.2 m above the person's body. If the pressure in this fluid is just barely able to push the fluid into the person, what is the

  4. Physics Fluids

    When a crown of mass 14.7 kg is submerged in water, an accurate scale reads only 13.4 kg. Is the crown made of real gold? Ok How do I do this problem I set up my free body diagram Net Force = ma = 0= Ft + Fb - Fg were Ft is the

You can view more similar questions or ask a new question.