Physics

In the figure, a small 0.125 kg block slides down a frictionless surface through height h = 0.958 m and then sticks to a uniform vertical rod of mass M = 0.250 kg and length d = 2.32 m. The rod pivots about point O through angle θ before momentarily stopping. Find θ.

  1. 👍
  2. 👎
  3. 👁

Respond to this Question

First Name

Your Response

Similar Questions

  1. physics

    [20 pts] A 2.00 kg block is pushed against a spring with negligible mass and force constant k = 400 N/m, compressing it 0.220 m. When the block is released, it moves along a frictionless, horizontal surface and then up a

  2. Physics

    A block of mass m = 2.00 kg is released from rest h = 0.500 m from the surface of a table, at the top of a theta = 30.0° incline. The frictionless incline is fixed on a table of height H = 2.00 m. (a) Determine the acceleration

  3. Impulse and Momentum

    A bullet of mass m is fired at speed v0 into a wooden block of mass M. The bullet instantaneously comes to rest in the block. The block with the embedded bullet slides along a horizontal surface with a coefficient of kinetic

  4. physics

    The 2 kg block in Figure 7-25 slides down a frictionless curved ramp, starting from rest at a height of h = 3 m. The block then slides d = 12 m on a rough horizontal surface before coming to rest. Figure 7-25 (a) What is the speed

  1. college physics

    A 0.50-kg block slides along a small track with elevated ends and a flat central part. The flat part has a length L = 1.85 m. The curved portions of the track are frictionless, but for the flat part the coefficient of kinetic

  2. Physics Help

    1.9 kg block slides along a frictionless surface at 1.8 m/s. A second block, sliding at a faster 4.5 m/s, collides with the first from behind and sticks to it. The final velocity of the combined blocks is 3.5 m/s. What was the

  3. physics emergency

    m1 = 2.7 kg block slides on a frictionless horizontal surface and is connected on one side to a spring (k = 40 N/m) as shown in the figure above. The other side is connected to the block m2 = 3.6 kg that hangs vertically. The

  4. Physics

    The drawing shows two frictionless inclines that begin at ground level (h = 0 m) and slope upward at the same angle θ. One track is longer than the other, however. Identical blocks are projected up each track with the same

  1. physics

    In Figure 8-50, a block slides along a track from one level to a higher level after passing through an intermediate valley. The track is frictionless until the block reaches the higher level, where a frictional force stops the

  2. Physics

    As shown in the figure below, a 2.25-kg block is released from rest on a ramp of height h. When the block is released, it slides without friction to the bottom of the ramp, and then continues across a surface that is frictionless

  3. Physics

    In Figure 8-34, a 1.2 kg block is held at rest against a spring with a force constant k = 695 N/m. Initially, the spring is compressed a distance d. When the block is released, it slides across a surface that is frictionless,

  4. physics

    I am having great difficulty with this question. A block is placed on a frictionless ramp at a height of 12.5 m above the ground. Starting from rest, the block slides down the ramp. At the bottom of the ramp, the block slides onto

You can view more similar questions or ask a new question.