Science physics

The least count of a screw gauge is 0.001cm the diameter of a wire measured by it is 0.225cm. Find out the percentage error in this measurement

  1. 👍
  2. 👎
  3. 👁
  1. Ddps

    1. 👍
    2. 👎

Respond to this Question

First Name

Your Response

Similar Questions

  1. physics

    Consider two copper wires with the same cross-sectional area. Wire A is twice as long as wire B. How do the resistivities and resistances of the two wires compare? CHECK ALL THAT APPLY Wire A and wire B have the same resistance.

  2. Physics

    The 3.0 cm-diameter water line splits into two 1.0cm-diameter pipes. All pipes are circular and at the same elevation. At point A, the water speed is 2.0m/s and the gauge pressure is 50kPa. What is the gauge pressure at point

  3. physics

    Find the diameter of an 18 m(L) long steel wire that will stretch no more than.009 m AL when a load stress of 3800 N is hung on the end of the wire. The Young's Modulus for steel wire is 200 x 109 N/m2?

  4. physics

    A light rigid bar is suspended horizontally from two vertical wires, one of steel and one of brass. Each wire is 2.00m long. The diameter of the steel wire is 0.60mm and the length of the bar AB is 0.20m. When a mass of 10.0kg is

  1. Physics

    At one point in a pipeline, the water's speed is 3.00 and the gauge pressure is 4.00×104 . Find the gauge pressure at a second point in the line 11.0 lower than the first if the pipe diameter at the second point is twice that at

  2. Physics

    A wire of 5.0m and diameter 2.0mm,extends by 0.25mm when a force of 50N was stretch it from it's end calculate a.the stress on the wire. b.the strain in the wire. c.the young's modulus of elasticity of the wire

  3. physics

    Practice Problem 13.9 Let's begin by looking at a flow problem in which the diameter of a pipe changes along the flow path. We will need to use both the continuity equation and Bernoulli's equation for this problem. Water enters a

  4. physics

    A force of 40N is applied at the end of a wire 4m long and produces an extension of 0.24mm. If the diameter of the wire is 2.00mm calculate the stress on the wire and strain in the wire. With full workings please

  1. physics

    The spring of the pressure gauge has a force constant of 1,000 N/m,and the piston has a diameter of 2.00 cm.when the gauge is lowered into water,at what depth does the piston move in by 0.500 cm?

  2. Physics

    Suppose a straight 1.60mm -diameter copper wire could just "float" horizontally in air because of the force due to the Earth's magnetic field B⃗ , which is horizontal, perpendicular to the wire, and of magnitude 4.2×10−5T .

  3. Physics

    1. A force of 40N at the end of a wire of length 4m and diameter 2mm process and extension of 0.24mm. Calculate; (a) stress on the wire (b) strain in the wire (c) Young's Modulous for the material of the wire (π=3.14)

  4. physics

    1. Two identical 15.0 kg balls, each 25.0 cm in diameter, are suspended by two 35.0 cm wires as shown in the figure. The entire apparatus is supported by a single 18.0 cm wire, and the surfaces of the balls are perfectly smooth.

You can view more similar questions or ask a new question.