Solid Mensuration

A metal hollow bar whose cross-section and dimensions are shown below weighs 8x10^3 kg/m^3 and measures 2m in lenght. Determine the mass of the metal bar with a square hole section.

  1. 0
  2. 1
asked by Gray
  1. what is the cross-section?

    1. 0
    posted by Steve

Respond to this Question

First Name

Your Response

Similar Questions

  1. physics

    Consider two straight bars of uniform cross section made of the same material. Bar 1 has an axial length of and a square cross section with side length . Bar 2 has an axial length of and a round cross section with diameter. When
  2. Physic

    Reaction at support and internal axial force resultant Consider two straight bars of uniform cross section made of the same material. Bar 1 has an axial length 1m of and a square cross section 1mm with side length . Bar 2 has an
  3. psuchics

    Reaction at support and internal axial force resultant Consider two straight bars of uniform cross section made of the same material. Bar 1 has an axial length 1m of and a square cross section 1mm with side length . Bar 2 has an
  4. spc

    a long strip of sheet metal 12 inches wide is to be formed into an open gutter with a rectangular cross-section as shown. what is the maximum possible area of the cross-section?
  5. chemistry

    A rectangular metal bar has a volume of 50.0 inches cubed.The Metal BaR weighs 1.42kg. Calculate the density of the metal in grams per cubic centimeter.
  6. physics

    A hypodermic needle consists of a plunger of circular cross-section that slides inside a hollow cylindrical syringe. When the plunger is pushed, the contents of the syringe are forced through a hollow needle (also of circular
  7. Chem Help!!

    A standard 1.000kg- mass is to be cut from a bar of steel having an equilateral triangular cross section with sides equal to 3.00in. The density of the steel is 7.70g/cm^3. How many inches long must the section of bar be?
  8. Math

    A length of a metal bar has a cross sectional square of 12cm. If the length is 2m, what is the volume of the metal bar in cm3?
  9. math

    carlos makes geometrical artworks out of sheet metal. the dimensions of a full size sculpture will be 6 times the dimensions of the model shown below. He will not use any metal for the bottom base of the cylinder. How many square
  10. statics and strengths

    A cantilever beam member made from steel with hollow circular cross section experiences an axial load of 300 KN (F1), and a vertical load of 200 kN (F2) as shown in the following figure. The beam is 300mm long and fixed on one

More Similar Questions