Chemistry

The bubble in the tip of the buret is not removed prior to performing the NaOH standardization. Will the reported concentration of the NaOH be greater than, less than, or equal to the true concentration of the NaOH if the bubble is flushed from the buret during the titration?

I think the concentration would be greater than, but I am not sure if that is correct. I know the calculated volume will be different. But will it actually change the concentration?

  1. 👍
  2. 👎
  3. 👁
  1. Of course. It will change the calculated volume and since you are measuring the volume of the titrant + the volume of the bubble, it will be larger.
    Since this is a molarity of the base, you will calculate M = mols/L
    The indicator will change when mols acid you're titrating is the same as mole NaOH added but volume NaOH is greater which makes the M.......?

    1. 👍
    2. 👎
  2. What is chemical compound

    1. 👍
    2. 👎

Respond to this Question

First Name

Your Response

Similar Questions

  1. acid-base titrations

    For each of the following circumstances, indicate whether the calculated molarity of NaOH would be lower, higher or unaffected. Explain your answer in each case. a.the inside of the pipet used to transfer the standard HCI solution

  2. Chemistry

    A titration setup was used to determine the unknown molar concentration of a solution of NaOH. A .025 M HCl solution was used as the titration standard. The following data were collected. Trial 1 Trial 2 Trial 3 Initial NaOH Buret

  3. Chemistry

    A student failed to notice an air bubble trapped in the tip of the buret during their experiment. What effect does this have on the calculated molarity of the NaOH solution?

  4. chemistry

    1. When performing this experiment, a student mistakenly used impure KHP to standardize the NaOH solution. If the impurity is neither acidic nor basic, will the percent by mass of acetic acid in the vinegar solution determined by

  1. CHEMISTRY PLEASE HELP

    a) How will the concentration of NaOH be affected if during the titration some of the solid potassium hydrogen phthalate was spilled during the transfer? Will the concentration of the standardized NaOH increase, decrease, or have

  2. Chemistry

    A student collected H2 gas in a buret by displacing water at 22.0 °C. The buret could not be submerged deep enough in a water bath to equalize the pressure. The water level in the buret was 18.2 cm above the water level in the

  3. physics

    A 1.6 air bubble is released from the sandy bottom of a warm, shallow sea, where the gauge pressure is 1.6 . The bubble rises slowly enough that the air inside remains at the same constant temperature as the water. What is the

  4. CHM general 2

    Indicated whether the calculated molarity of NaOH would be lower or higher Than the real value; or unaffected? a) the water of the NaOH solution is not boiled and cooler before the solution is prepared b) The buret, wet with

  1. APChem

    If an air bubble passes unnoticed through the tip of a buret during a titration (where a weak nonvolatile acid HA is the analyte) , the calculated molar mass of HA would be too high, too low, or not affected? I thought it would be

  2. Org. Chem.

    what is the precipitate formed when HCl is added? I believe the answer is NaCl, but I am not sure and this precipitate only formed in the first NaOH extract, as precipitate was essentially nonexistent in the 2nd extract? Below is

  3. AP CHEMISTRY HELP

    a) A student fails to wash the weighing paper when transferring the KHP sample into the beaker. What effect does this error have on the calculated molarity of the NAOH solution? Mathematically justify your answer. b) A student

  4. Chemistry

    Titration of an Unknown Acid... What effect on the molar mass of the unknown acid would each of the following have... Would it make the calculated molar mass high, low, or would it have no effect? 1. Adding 5 drops of

You can view more similar questions or ask a new question.