Chem

Calibration data for a bromide ion-selective electrode (ISE) was collected and recorded below. The potential of the ISE was measured against a saturated calomel electrode (SCE). All solutions were buffered at a pH of 7.56. A linear calibration curve can be constructed from this data as a plot of potential vs. log[Br-]. Determine the slope and y-intercept of such a plot of the calibration data given.

Find the slope and the y-intercept.

Two unknown solutions were tested for [Br–] using the same bromide ISE. The potential reading for unknown 1 was 13.4 mV and the potential reading for unknown 2 was 181.9 mV. Using the calibration curve you constructed above, determine the concentration of Br– in each unknown solution.

I have done this problem multiple times (5 times) and I cannot figure out what I am doing wrong. I got the slope but not the intercept.

asked by Cassie
  1. I hope you revisited the ethanol problem After your last post I found two errors; one yours and one mine.

    posted by DrBob222

Respond to this Question

First Name

Your Answer

Similar Questions

  1. Chem

    Calibration of a glass electrode gave a reading of 139.3 mV with 0.05 m potassium dihydrogen citrate buffer standard (pH = 3.766) and a reading of -79.0 mV with 0.08 m HEPES, 0.08 m NaHEPES, 0.08 m NaCl buffer standard (pH =
  2. Chemistry

    A chemist wishes to determine the concentration of CrO4-2 ions electrochemically. A cell is constructed consisting of saturated calomel electrode (SCE) and a silver wire coated with Ag2CrO4. The SCE is composed of mercury in
  3. chemistry

    A chemist wishes to determine the concentration of CrO4-2 ions electrochemically. A cell is constructed consisting of saturated calomel electrode (SCE) and a silver wire coated with Ag2CrO4. The SCE is composed of mercury in
  4. electrochemistry

    What is the anode and cathode of this problem? A chemist wishes to determine the concentration of CrO4-2 ions electrochemically. A cell is constructed consisting of saturated calomel electrode (SCE) and a silver wire coated with
  5. Clinical Chemistry

    Why is slightly higher serum sodium consistently found by evaluation by ion-selective electrode (ISE) as compared to flame photometry?
  6. chemistry

    Q1) How many resonances are expected in the 13C NMR spectrum of propan-1-ol? Q2) A student measures the EMF of the following electrochemical cell at 31oC in a solution that is 0.22 molL-1 in Hg2+ against a Saturated Calomel
  7. chemistry

    When an ion-selective electrode for X was immersed in 0.0210 M XCl, the measured potential was 0.0480 V. What is the concentration of X when the potential is 0.0630 V? Assume that the electrode follows the Nernst equation, the
  8. Chem

    When an ion-selective electrode for sulfate was immersed in 0.0300 M sodium sulfate, the measured potential was 0.0460 V. What is the concentration of sulfate when the potential is 0.0610 V? Assume that the electrode follows the
  9. Clinical Chemistry

    I have 2 questions relating to clinical chemistry... 1st: I have no idea where to even start with this. It seems like it should be simple, but I have no clue. The question is... "In serum, about 55% of total serum calcium is
  10. Electrochemistry

    Ag2CrO4(s) + 2e- 2Ag(s) + CrO42-(aq) A chemist wishes to determine the concentration of CrO42- electrochemically. A cell is constructed consisting of a saturated calomel electrode (SCE; which has a reduction potential of 0.242 V

More Similar Questions