engg

At a point in a plate subjected to plane stress loading along its surface, the cartesian stress components acting on the x-face of an element oriented along the (x,y) frame are σx=40MPa and τxy=70MPa,
The maximum allowable shear stress, to prevent yielding of the material, is τo=74MPa.

What is the permissible range (minimum and maximum values in MPa) for the normal stress on the y-face, σy, to ensure that the material will not yield?

asked by knndk

Respond to this Question

First Name

Your Answer

Similar Questions

  1. Materials Science

    At a point in a plate subjected to plane stress loading along its surface, the cartesian stress components acting on the x-face of an element oriented along the (x,y) frame are σx=40MPa and τxy=70MPa, The maximum
  2. Mechanical behavior

    At a point in a plate subjected to plane stress loading along its surface, the cartesian stress components acting on the y-face of an element oriented along the (x,y) frame are σy=8MPa and τxy=16MPa, The maximum
  3. Mechanical Behavior of Materials

    At a point in a plate subjected to plane stress loading along its surface, the cartesian stress components acting on the y-face of an element oriented along the (x,y) frame are σy=8MPa and τxy=16MPa, The maximum
  4. Materials Science

    In this problem, you will construct the 2D Mohr's circle for two plane stress states defined in terms of the Cartesian components of the stress tensor in the x,y reference frame: [ σx,σy,τxy]. For each of these
  5. Materials Science

    A compression bar, having a square cross section of side length b, must support a compressive load of magnitude W, uniformly distributed over the bar cross section. The bar is made of two segments connected by a glued joint along
  6. Engineering

    A plane element is subjected to a shear stress τ = 360MPa which results to a shear strain σ = 0.008rad. a) determine the shear modulus G of the element b)What is the horizontal displacement, d, of the element if te
  7. Materials Science

    A thin-wall cylindrical tank has radius R, wall thickness t≪R and is subjected to an internal pressure p. The cylindrical wall of the tank is constructed by welding steel plates along 45∘ seams, Consider a small
  8. stress

    The shear stress in a plane normal of which makes an angle of 30 degree with the direction of maximum principal stress will be ?
  9. solid mechanics

    at a point in a strained material the principal stresses are 60MPa and 40MPa.find the position of the plane across which the resultant stress is most inclined to the normal and determine the value of this stress.
  10. B-Tech mechanical

    At a point in a strained material the principal stresses are 60MPa and 40MPa. Find the position of the plane across which the resultant stress is most inclined to the normal and determine the value of this stress.

More Similar Questions