Chemistry

Why are alum rystals not supposed to washed in pure water?

  1. 👍 0
  2. 👎 0
  3. 👁 328
  1. Because they are soluble in water.

    1. 👍 0
    2. 👎 0
    posted by DrBob222

Respond to this Question

First Name

Your Response

Similar Questions

  1. Chemistry

    I had a 1.094g of mystery Alum. "AB(SO4)c. dH2O" (I assume that that the Alum is KAl(SO4)2-12H2O but we don't know A B c or d, we do know that mass percent of water is 51.9) After processing the alum (Ba(NO3)2 and HNO3 through a

    asked by Graham on February 1, 2013
  2. Chemistry

    How would I find the percent of water lost in alum after it has dried for a week? Wet Alum = 13.44g Dry Alum = 11.28g

    asked by Zach on September 11, 2012
  3. AP Chemistry

    1. If alum is heated at first too strongly causing it to splatter out of the crucible what effect will this have on the determination of the water hydration? 2. If alum is heated insufficiently what effect will this have on the

    asked by Nicole on October 11, 2014
  4. Chemistry

    Alum is a hydrated compound containing 45.5% water. How many moles of water are contained in one mole of this hydrate. Data for alum M= 474 g∙mol-1

    asked by Dan on April 8, 2010
  5. chemisty

    what will be the mass of angydrous Alum left over if one starts with 100.00 g of hydrated Alum? please can you explain what fraction do I need to use. Based on the given information I can find the %theoretical of water in

    asked by Jay on October 21, 2010
  6. chemistry

    Why is it wise to clean the aluminum? Why is the reaction done in the hood? Why must suspended solids be removed from the basic solution? Why is an ethanol-water mixture, rather than pure water, used to wash the collected alum?

    asked by Josh on July 27, 2008
  7. Environmental Science

    What is the purpose of adding alum to water during the water treatment process? a.to filter and remove large organisms and trash b.to form flocs that bacteria and other impurities will cling to c.to prevent bacterial growth d.to

    asked by Mack on April 20, 2007
  8. Chemistry lab

    1)Why is it necessary to heat the alum until its mass does not change by more than 2mg? 2)Why its it necessary to store the alum in a disccator while it cools before measuring the mass? ( systhesis and analysis of alum crystals

    asked by Paul on February 23, 2016
  9. chem

    What do question about Aluminum, hand this is some general question about it can someone help me to answer them Why is it wise to clean the aluminum? Why is the reaction done in the hood? Why must suspended solids be removed from

    asked by Josh on July 27, 2008
  10. chemistry

    Porassium alum is 3.9 parts per 100 parts of water. Knowing this, how many moles of potassium alum are present in 50ml?

    asked by Lex on October 19, 2012

More Similar Questions