Physics

A cylinder with a movable piston encloses 0.39 mole of ideal gas at 308K . How much heat is required to increase its volume isothermally by a factor of 3?
1100J
1400J
1600J
550J

  1. 👍 0
  2. 👎 0
  3. 👁 175

Respond to this Question

First Name

Your Response

Similar Questions

  1. physics

    A cylinder that has a 40.0 cm radius and is 50.0 cm deep is filled with air at 20.0°C and 1.00 atm. A 21.0 kg piston is now lowered into the cylinder, compressing the air trapped inside. Finally, a 79.0 kg man stands on the

  2. CHEM

    A) a picture shows a container that is sealed at the top by a movable piston. Inside the container is a ideal gas at 1.00atm , 20.0 *C, and 1.00L. (The pic is of a 2L container which has a piston pushed downward to the 1L level.

  3. thermodynamic

    Energy is added to a piston-cylinder arrangement. The piston is withdrawn in such a way that the temperature remains constant. The initial pressure and volume are 200 KPa and 2m^3, respectively. If the final pressure is 100 KPa,

  4. Chemistry

    A sample of gas confined in a cylinder with a movable piston is kept at constant pressure. The volume of the gas doubles when the temperature of the gas is changed from a. 200. K to 400. K b. 200. C to 400. C How do you know if

  1. Physics

    The drawing shows an ideal gas confined to a cylinder by a massless piston that is attached to an ideal spring. Outside the cylinder is a vacuum. The cross-sectional area of the piston is A = 2.50 10-3 m2. The initial pressure,

  2. chemistry

    A cylinder is filled with 10.0L of gas and a piston is put into it. The initial pressure of the gas is measured to be 200.kPa. The piston is now pushed down, compressing the gas, until the gas has a final volume of 3.10L.

  3. HVAC

    A gas is compressed inside a compressors cylinder. When the piston is at its bottom dead center , the gas is initially at 10 psig , 65 degree and 10.5 in. After compression and when the piston is at top dead center the gas is 180

  4. Physics

    The pressure of a gas in a cylinder with a movable piston is increased from 45 kPa to 90 kPa. If the temperature is held constant, and the initial volume of the gas in the cylinder is 0.5 m3, what is the final volume of the gas?

  1. Physics

    A cylinder with a valve at the bottom is filled with an ideal gas. The valve is now opened and some of the gas escapes slowly. The valve is then closed, after which the piston is observed to be at a lower position. Assume that the

  2. Physics

    A cylinder with a movable piston contains gas at a temperature of 27 degrees celsius, a volume of 1.50 meters cubed, and an absolute pressure of 0.200 X 10 to the fifth Pa. What will be its final temperature if the gas is

  3. CHEM

    A cylinder with a movable piston contains 2.00g of helium, He, at room temperature. More helium was added to the cylinder and the volume was adjusted so that the gas pressure remained the same. How many grams of helium were added

  4. chemistry

    A certain amount of chlorine gas was placed inside a cylinder with a movable piston at one end. The initial volume was 3.00 and the initial pressure of chlorine was 1.75 . The piston was pushed down to change the volume to 1.00 .

You can view more similar questions or ask a new question.