-
- 👍 0
- 👎 0
posted by drwls
Respond to this Question
Similar Questions
-
Physics
A 100 W lamp is connected to 120 V, and its current is measured. A resistor is added to the lamp to reduce the current to half its original value. (a) What is the potential difference across the lamp? (b) How much resistance was
asked by Billy on April 14, 2013 -
Physics
An electric drill operates at a potential difference of 120V and draws a current of 1.5 Amps. If it takes 50 seconds to drill a hole in a piece of steel,calculate the amount of electrical energy used by the drill in that time.
asked by Don on May 18, 2012 -
Physics - electricity
An incandescent lamp is marked '120v,75W' a)what is the current in the lamp under normal condition of operation? b)How much does it cost per hour to operate the lamp if the price of electrical energy is $6.00 per unit? Please stop
asked by Charles on April 17, 2007 -
Physics science
A 10 ohm, 20 ohm lamp and 12v battery are connected in a parallel. A current of 1.8 A passes through the battery and a current of 1.2 A passes through the motor. 1) Determine the current through the lamp. 2) Calculate the
asked by Tina on November 10, 2016 -
Physics
1)A 2.0-V battery is connected in a circuit with an ammeter and an unknown resistor, P. The current is observed to be 0.70 A. What would be the current in the circuit if a 12-V battery replaces the 2.0-V battery? A)4.2 A B)6.0 A
asked by Jon on April 9, 2008 -
Physics
Calculate the power of a hair dryer that operates on 120V and draws a current of 10 A.
asked by jamya on May 12, 2013 -
physics
A light bulb, after it has reached its operation temperature, is connected across a potential difference of 120V while 0.5A of current passses through it. What is the resistance of the light bulb?
asked by joh on September 28, 2009 -
physics
A. State Ohm’s law B.Describe the process of electrolysis C. What is the relationship between resistance and resistivity D. What is the current through 8Ω device operating with 120V The potential difference required to pass 3A
asked by Chansa on May 17, 2016 -
physics
A 15.0 Ohms resistor is connected in series to a 120V generator and two 10.0 Ohms resistors that are connected in parallel to each other. -What is the total resistance of the load? -What is the magnitude of the circuit current?
asked by Rony on February 17, 2010 -
physics
A source of instantaneous potential V = 10sin(50pi t) is connected across a capacitor of capacitence 1 times 10power negative 6 F. calculate the maximum value of the current and phase difference between the current and the
asked by Allan on April 18, 2012