chemistry

posted by mino

Why do you add Sodium hydroxidein your reduction procedure

  1. DrBob222

    Reduction procedure for what? to what? with what? What are you doing? My crystal ball is hazy today.

Respond to this Question

First Name

Your Answer

Similar Questions

  1. Chemistry

    I posted before about designing a procedure to determine two unknowns (1 solid, 1 solution). The possible solutions were: NaCl, CaCl2, CuSO4, NaOH,Ba(OH)2, HCl, HNO3, or H2O. The reagents given are: NaOH, HCl, AgNO3, Zn metal, Na2SO4, …
  2. chem

    I had to go and do a oxidation- reduction lab where: I went oxidized borneol with sodium chloride and added 0.360g racemic borneol, 1ml acetone, and .30ml glacial acetic acid. Then I heated and added through the condenser every 4 minutes …
  3. Chemistry

    Hello, I had a lab about calorimetry and one of the questions was if the reaction of acetone with hypochlorite is an oxidation/reduction or acid/base. Would the answer be: oxidation/reduction because the oxygen from the hydroxide from …
  4. organic chemistry

    Describe and explain how each of the following experimental errors or variations might affect your results. (a) you failed to dry the reaction flask after washing it with water. (b) you forgot to add the sulfuric acid. (c) you used …
  5. Chem

    Consider the reduction of 4-t-butylcyclohexanone. If the procedure calls for 153 mg of 4-t-butylcyclohexanone, what mass of sodium borohydride should be added?
  6. Chemistry

    Consider the reduction of 4-t-butylcyclohexanone. If the procedure calls for 153 mg of 4-t-butylcyclohexanone, what mass of sodium borohydride should be added?
  7. DR BOB PLEASE HELP CHEM

    Consider the reduction of 4-t-butylcyclohexanone. If the procedure calls for 153 mg of 4-t-butylcyclohexanone, what mass of sodium borohydride should be added?
  8. chemistry

    a sodium hydroxide solution was prepared according to the procedure outlined in this weeks experiment. This sodium hydroxide solution was standardized by by titration against exactly 10mL of a 0.28M hydrochloric acid solution. In three …
  9. Chemistry

    Write a procedure to demonstrate the effect of higher concentrations of HCl on its rate of reaction with antacid tablets. I have HCl with a concentration of 1.0 mol/L. This is what I have so far. Are my concentrations correct for this …
  10. AP Chemistry

    Sodium can be extracted by heating naturally occurring salt until it is molten. An electrochemical process is then used to extract the sodium. Cl2 is produced at the anode, and Na is collected at the cathode. 1. Write the half-reactions …

More Similar Questions