Physics

posted by .

an open tank contains a layer of oil floating on top of a layer of water (of density 1000 kg/m3) that is 3.0 m thick, as shown. What must be the thickness of the oil layer if the gauge pressure at the bottom of the tank is to be 9.1×104 Pa? The density of the oil is 880 kg/m3?

  • Physics -

    4.28

Respond to this Question

First Name
School Subject
Your Answer

Similar Questions

  1. physics

    A 2.6 cm thick bar of soap is floating on a water surface so that 2.14 cm of the bar is underwater. Bath oil (of specific gravity 0.8)is poured into the water and floats on top of the water. What is the depth of the oil layer when …
  2. Physics

    A 2.0-cm thich bar of soap is floating on a water surface so that 1.5 cm of the bar is under water. Bath oil of specific gravity 0.60 is poured into the water and floats on top of it. What is the depth of the oil layer when the top …
  3. Physics

    A 2.0-cm thich bar of soap is floating on a water surface so that 1.5 cm of the bar is under water. Bath oil of specific gravity 0.60 is poured into the water and floats on top of it. What is the depth of the oil layer when the top …
  4. organic chemistry

    Why does the alkyl halide layer switch from the top layer to the bottom layer at the point where water is used to extract the organic layer?
  5. Physics

    an oil layer floats on 87 cm of water in a tank. the pressure at the bottom of the tank is 120.0 kPa. How thick is the oil?
  6. Physics

    A bucket is filled with a combination of water (density 1,000 kg/m3) and oil (density 700 kg/m3). These fluids do not mix. (The oil will float on top of the water.) If the layer of oil is 63 cm tall, what is the pressure at the interface …
  7. Physics

    Suppose you pour water into a container until it reaches a depth of 12 cm. Next, you pour in a 25-cm-thick layer of oil so that it floats on top of the water. The density of the oil is 0.92 g/cm3 and that of water is 1.00 g/cm3. What …
  8. Physics

    A cubical block of wood 0.100 m on a side and with a density 550 kg/m^3 of floats in a jar of water. Oil with a density of 750 kg/m^3 is poured on the water until the top of the oil layer is 0.035 m below the top of the block. 1. How …
  9. Physics

    In a huge oil tanker, salt water has flooded an oil tank to a depth of h2 = 4.50 m. On top of the water is a layer of oil h1 = 7.55 m deep, as in the cross-sectional view of the tank as shown in the figure. The oil has a density of …
  10. solar homework

    We have discussed that a bare crystalline silicon surface contains many defects which act as SRH recombination centers. How can the surface recombination at the air/n-silicon interface be reduced?

More Similar Questions