physics

posted by .

A graduated cylinder is inverted in a very large bucket of water. The depth of the water in the container is 6 m and the top of the bucket is open to the air in the room. The mouth (bottom) of the graduated cylinder is 4 m above the bottom of the container. Due to a pressure difference, the water in the graduated cylinder rises 3 m above the surface of the water in the container. calculate the pressure at the following locations:
A-Surface of water in bucket
B-bottom of bucket
C-at mouth of cylinder
D-in cylinder level with water in bucket
E-top of water in cylinder

Respond to this Question

First Name
School Subject
Your Answer

Similar Questions

  1. math

    how do you measure and get 4 gallons of water only having an unmarked 5 gallon bucket and an unmarked 3 gallon bucket and a large container of water ok this is simple, u just have to think out of the bucket...heh.. so here goes fill …
  2. 11th grade Physics

    An open pipe 0.40m in length is placed vertically in a cylindrical bucket having a bottom area of 0.10 m^2. Water is poured into the bucket until a sounding tuning fork of frequency 440 Hz, placed over the pipe, produces resonance. …
  3. science

    Imagine that you fill a bucket to the top with water and then place the bucket outside in freezing weather. Which of the following describes what will happen when the water in the bucket freezes?
  4. physics

    You have tied a short length of rope to the handle of a bucket full of water, and are swinging the bucket in a vertical circle with radius 60 cm. What is the minimum speed that the bucket must be moving in order for no water to spill …
  5. Physics

    You raise a bucket of water from the bottom of a well that is 12 m deep. The mass of the bucket and the water is 5.00 kg, and it takes 15 s to raise the bucket to the top of the well. How much power is required?
  6. Physics

    You raise a bucket of water from the bottom of a well that is 12 m deep. The mass of the bucket and the water is 5.00 kg, and it takes 15 s to raise the bucket to the top of the well. How much power is required?
  7. physics

    a rope is tied to a bucket of water, and the bucket is swung in a vertical circle of radius 1.2m. what must be the minimum speed of the bucket at the highest point of the circle if the water is to stay in the bucket throughtout the …
  8. physics

    You raise a bucket of water from the bottom of a well that is 12 m deep. The mass of the bucket and the water is 5.00 kg, and it takes 15 s to raise the bucket to the top of the well. Part A How much power is required?
  9. Physics

    A solid, uniform, frictionless cylindrical reel of mass M = 3.00 kg and radius R = 0.400 m is used to draw water from a well.?
  10. calculus

    A bucket that weighs 4 lb and a rope of negligible weight are used to draw water from a well that is 70 ft deep. The bucket is filled with 44 lb of water and is pulled up at a rate of 2 ft/s, but water leaks out of a hole in the bucket …

More Similar Questions